CAMSHAFT POSITION SENSOR REMOVAL


  1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A01HQOT

      Lift the rear of the engine cover to detach the cover from the 2 pins, and then lift the front of the engine cover to detach the cover from the pin and remove the engine cover.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover sub-assembly to break.

  2. REMOVE CAMSHAFT POSITION SENSOR


    1. Camshaft position sensor (for Exhaust Side)


      1. A01HNE8

        Disconnect the sensor connector.

      2. Remove the bolt and sensor.

    2. Camshaft position sensor (for Intake Side)


      1. A01HPVE

        Disconnect the sensor connector.

      2. Remove the bolt and sensor.