ACCELERATOR PEDAL ON-VEHICLE INSPECTION


  1. CHECK ACCELERATOR PEDAL SENSOR ASSEMBLY


    1. Measure the voltage.


      1. Connect the Techstream to the DLC3.

      2. Turn the ignition switch to ON.

      3. Turn the Techstream on.

      4. Enter the following menus: Powertrain / Engine and ECT / Data List / Gas Throttle / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.

      5. Read the value displayed on the Techstream.

        Standard Voltage
        Accelerator Pedal Operation Accel Sensor Out No. 1 Accel Sensor Out No. 2
        Fully Released 0.5 to 1.1 V 1.2 to 2.0 V
        Fully Depressed 2.6 to 4.5 V 3.4 to 4.98 V

        If the result is not as specified, check the accelerator pedal sensor assembly, wire harness or ECM.