DESCRIPTION
The TCM monitors its internal operation and it will set this DTC when it detects an internal malfunction.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P062F | TCM internal error (EEPROM) | TCM |
MONITOR DESCRIPTION
The TCM monitors its internal operation. If the internal operation is malfunctioning, the TCM illuminates the MIL and sets a DTC.
MONITOR STRATEGY
| Related DTCs | P062F: Internal control module EEPROM error |
| Required sensors/Components (Main) | TCM |
| Required sensors/Components (Related) | - |
| Frequency of operation | Once per driving cycle |
| Duration | 11 seconds |
| MIL operation | Immediate |
| Sequence of operation | None |
TYPICAL ENABLING CONDITIONS
| Monitor runs whenever following DTCs not present | None |
| Time after engine start | 10 seconds or more |
| Battery voltage | 8 V or higher |
| Engine switch | on (IG) |
| Starter | OFF |
TYPICAL MALFUNCTION THRESHOLDS
| Permanent fault code data | Mismatch (3 times or more) |
INSPECTION PROCEDURE
Note
After turning engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.
Perform the universal trip to clear permanent DTCs Click here.
PROCEDURE
READ OUTPUT DTC (DTC P062F)
Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Clear DTCs Click here.
Turn the engine switch off and turn the Techstream off.
Disconnect the Techstream.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Select the following menu items: Powertrain / ECT / Trouble Codes.
Read DTCs.
| Result | Proceed to |
|---|---|
| No output | A |
| P062F | B |
| B |
|
REPLACE TCM Click here |
| A |
|
CHECK FOR INTERMITTENT PROBLEMS Click here