REAR CRANKSHAFT OIL SEAL INSTALLATION


  1. INSTALL ENGINE REAR OIL SEAL


    1. A01HQ7KE03
      Text in Illustration
      *1 Retainer
      *a

      Oil seal tap in depth

      (-0.5 to 0.5 mm)

      Apply MP grease to a new engine rear oil seal lip.

    2. Using SST and a hammer, tap in the engine rear oil seal.

      SST
      09223-15030
      09950-70010   ( 09951-07150 )
      Oil seal tap in depth
      -0.5 to 0.5 mm (-0.0196 to 0.0196 in.)

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. Using SST, hold the crankshaft pulley.

      SST
      09213-70011   ( 09213-70020 )
      09330-00021

    2. Clean the 8 bolts and 8 bolt holes.

    3. A01HN4Q

      Install the front drive plate spacer.

      Tech Tips

      Align the pin of the front drive plate spacer with the pin hole of the crankshaft.

    4. A01HPIAE03
      Text in Illustration
      *1 Drive Plate
      *2 Rear Spacer
      A01HNYE Transaxle Side

      Install the drive plate and ring gear sub-assembly and rear drive plate spacer onto the crankshaft.

    5. A01HQH6E12
      Text in Illustration
      *1 Adhesive

      Apply adhesive to 2 or 3 threads of each bolt.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    6. A01HQGIE01

      In several steps, uniformly install and tighten the 8 bolts in the sequence shown in the illustration.

      Torque:
      83 N*m  { 846 kgf*cm, 61 ft.*lbf }

      Note

      Do not start the engine for at least an hour after installing the drive plate.

  3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY

    Click here