FRONT CRANKSHAFT OIL SEAL INSTALLATION


  1. INSTALL TIMING CHAIN CASE OIL SEAL


    1. A01HORUE06
      Text in Illustration
      *a

      Oil seal tap in depth

      (0 to 1.0 mm)

      Apply MP grease to a new timing chain case oil seal lip.

    2. Using SST and a hammer, tap in the timing chain case oil seal until its surface is flush with the timing chain cover edge.

      SST
      09223-22010
      09506-35010
      Oil seal tap in depth
      0 to 1.0 mm (0 to 0.0393 in.)

      Note


      • Keep the lip free of foreign matter.

      • Do not tap the timing chain case oil seal at an angle.

  2. INSTALL CRANKSHAFT PULLEY


    1. Align the pulley set key with the key groove of the pulley, and slide on the pulley.

    2. A01HNYUE03
      Text in Illustration
      *a Hold
      A01HNYE Turn

      Using SST, install the pulley bolt.

      SST
      09213-70011   ( 09213-70020 )
      09330-00021
      Torque:
      250 N*m  { 2550 kgf*cm, 184 ft.*lbf }

  3. INSTALL V-RIBBED BELT


    1. A01HQX9E02
      Text in Illustration
      *1 Water Pump
      *2 Idler
      *3 Generator
      *4 Crankshaft
      *5 Tensioner
      *6 A/C Compressor

      Install the V-ribbed belt.

    2. A01HQFB

      Turn the V-ribbed belt tensioner counterclockwise and remove the 5 mm hexagon wrench.

    3. After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the belt has not slipped out of the grooves on the bottom of the crank pulley by hand.

  4. INSTALL FRONT FENDER APRON SEAL RH

  5. INSTALL ENGINE UNDER COVER RH

  6. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH

  7. INSTALL FRONT WHEEL RH

    Torque:
    103 N*m  { 1049 kgf*cm, 76 ft.*lbf }