ACCELERATOR PEDAL ON-VEHICLE INSPECTION


  1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY


    1. Connect the Techstream to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the Techstream on.

    4. Enter the following menus: Powertrain / Engine / Data List / All Data / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.

    5. Read the values displayed on the Techstream.

      Standard Voltage
      Accelerator Pedal Operation Accel Sensor Out No. 1 Accel Sensor Out No. 2
      Fully released 0.5 to 1.1 V 1.2 to 2.0 V
      Fully depressed 2.6 to 4.5 V 3.4 to 4.75 V

      If the result is not as specified, check the accelerator pedal sensor assembly, wire harness or ECM.