ENGINE COOLANT TEMPERATURE SENSOR REMOVAL


  1. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

  2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

  3. REMOVE ENGINE UNDER COVER LH

  4. REMOVE ENGINE UNDER COVER RH

  5. DRAIN ENGINE COOLANT

    Note

    Do not remove the radiator cap sub-assembly or radiator drain cock plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


    1. Loosen the radiator drain cock plug.

    2. Remove the radiator cap sub-assembly.

      A01HP2DE01
      Text in Illustration
      *1 Radiator Cap Sub-assembly *2 Radiator Drain Cock Plug

      Tech Tips

      Collect the coolant in a container and dispose of it according to the regulations in your area.

  6. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A01HQOT

      Lift the rear of the engine cover to detach the cover from the 2 pins, and then lift the front of the engine cover to detach the cover from the pin and remove the engine cover.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover sub-assembly to break.

  7. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01HOR8

      Remove the 7 clips and cool air intake duct seal.

  8. REMOVE INLET AIR CLEANER ASSEMBLY


    1. A01HN8W

      Remove the 2 bolts and inlet air cleaner assembly.

  9. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. A01HMV1

      Disconnect the engine coolant temperature sensor connector.

    2. A01HQ4D

      Remove the 2 bolts and disconnect the wire harness.

    3. A01HPRVE01
      Text in Illustration
      *1 Ball Joint Lock Nut Wrench
      *2 Gasket

      Using a 19 mm ball joint lock nut wrench, remove the engine coolant temperature sensor.

    4. Remove the gasket from the engine coolant temperature sensor.