PARK / NEUTRAL POSITION SWITCH REMOVAL


  1. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01HOR8

      Remove the 7 clips and cool air intake duct seal.

  2. REMOVE INLET NO. 2 AIR CLEANER


    1. A01HPAY

      Disconnect the 2 wire harness clamps and vacuum hose clamp.

    2. Remove the 2 bolts and inlet No. 2 air cleaner.

  3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A01HPC3

      Disconnect the mass air flow meter connector and wire harness clamp.

    2. A01HN6O

      Disconnect the 3 hoses.

    3. Separate the ventilation hose.

    4. A01HMZ1

      Loosen the hose clamp and separate the air cleaner cap sub-assembly from the throttle with motor body assembly.

    5. Release the 2 clamps and remove the air cleaner cap with hose.

  4. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. A01HODT

      Disconnect the wire harness clamp, connector, vacuum hose and No. 1 fuel vapor feed hose.

    2. Remove the 2 bolts and air cleaner case sub-assembly.

  6. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. A01HPIB

      Disconnect the wire harness clamp.

    3. A01HMOI

      Remove the nut from the control shaft lever.

    4. Remove the clip and disconnect the transmission control cable from the control cable bracket.

  7. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. Disconnect the connector from the park/neutral position switch.

    2. A01HOCK

      Remove the nut, washer and control shaft lever from the control shaft.

    3. A01HQ1F

      Remove the 2 bolts and park/neutral position switch from the control shaft.

      Note

      Before removing the park/neutral position switch, remove any dirt or rust on the installation portion of the control shaft. Be sure to remove the switch straight along the shaft while being careful not to deform the plate spring that supports the shaft. If the plate spring is deformed, the park/neutral position switch cannot be reinstalled correctly.