TCM REMOVAL

Note

If automatic transmission parts are replaced, refer to Parts Replacement Compensation Table to determine if any additional operations are necessary Click here.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01HOR8

      Remove the 7 clips and cool air intake duct seal.

  3. REMOVE INLET NO. 2 AIR CLEANER


    1. A01HPAY

      Disconnect the 2 wire harness clamps and vacuum hose clamp.

    2. Remove the 2 bolts and inlet No. 2 air cleaner.

  4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A01HPC3

      Disconnect the mass air flow meter connector and wire harness clamp.

    2. A01HN6O

      Disconnect the 3 hoses.

    3. Separate the ventilation hose.

    4. A01HMZ1

      Loosen the hose clamp and separate the air cleaner cap sub-assembly from the throttle with motor body assembly.

    5. Release the 2 clamps and remove the air cleaner cap with hose.

  5. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  6. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. A01HODT

      Disconnect the wire harness clamp, connector, vacuum hose and No. 1 fuel vapor feed hose.

    2. Remove the 2 bolts and air cleaner case sub-assembly.

  7. REMOVE BATTERY


    1. A01HN96

      Disconnect the positive (+) cable from the positive (+) battery terminal.

    2. Loosen the nut and remove the bolt.

    3. Remove the battery and battery tray.

  8. REMOVE BATTERY TRAY

  9. REMOVE INLET NO. 1 AIR CLEANER


    1. A01HNDX

      Disengage the pin and remove the inlet No. 1 air cleaner.

  10. REMOVE TCM


    1. A01HNV8

      Turn the lock lever and disconnect the connector from the TCM.

    2. A01HR1U

      Remove the 2 bolts and TCM from the automatic transaxle assembly.