- Click here
INSPECT ENGINE SWITCH
-
Measure the resistance according to the value(s) in the table below.
Standard Resistance Tester Connection Switch Condition Specified Condition 7 (SS1) - 5 (GND)
2 (SS2) - 5 (GND)
Not pushed 10 kΩ or higher 7 (SS1) - 5 (GND)
2 (SS2) - 5 (GND)
Pushed Below 1 Ω Table 1. Text in Illustration *a Component without harness connected
(Engine Switch)
If the result is not as specified, replace the engine switch.
-
Apply battery voltage between the terminals of the switch, and check the illumination condition of the switch.
Tip:
-
If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.
-
If the voltage is too low, the indicator will not illuminate.
OK Measurement Condition Specified Condition Battery positive (+) → Terminal 11 (SWIL)
Battery negative (-) → Terminal 5 (GND)
Illuminates (illumination of lettering) Battery positive (+) → Terminal 12 (INDS)
Battery negative (-) → Terminal 5 (GND)
Illuminates (green) Battery positive (+) → Terminal 13 (INDW)
Battery negative (-) → Terminal 5 (GND)
Illuminates (amber) Table 2. Text in Illustration *1 Indicator - - *a Component without harness connected
(Engine Switch)
- - If the result is not as specified, replace the engine switch.
-
-