УСТАНОВИТЕ ДАТЧИК УРОВНЯ МОТОРНОГО МАСЛА
Установите новую прокладку на датчик уровня моторного масла.
Закрепите датчик уровня моторного масла и 4 болтами.
| 7,0 Н*м | 71 кгс*см | 62 фунт-сила-дюйма |
Подсоедините разъем.
ПОДСОЕДИНИТЕ ПАТРУБОК МАСЛЯНОГО РАДИАТОРА
Подсоедините патрубок масляного радиатора и закрепите его 2 болтами.
| 14 Н*м | 143 кгс*см | 10 фунт-сила-футов |
ЗАЛЕЙТЕ МОТОРНОЕ МАСЛО
Добавьте свежее масло и установите крышку маслоналивной горловины.
| Стандартный класс масла по степени вязкости | ||||||
|---|---|---|---|---|---|---|
|
| Стандартный объем масла | ||||||||
|---|---|---|---|---|---|---|---|---|
|
ПРОВЕРЬТЕ УРОВЕНЬ МОТОРНОГО МАСЛА
Warm up the engine. Then stop the engine and wait for 5 minutes.
Check that the engine oil level is between the dipstick low level mark and full level mark.
| *a | Measuring Surface |
| *b | Low Level Mark |
| *c | Full Level Mark |
If the level is low, check for leakage and add oil up to the full level mark.
Do not fill engine oil above the full level mark.
A certain amount of engine oil will be consumed while driving. In the following situations, oil consumption may increase, and engine oil may need to be refilled in between oil maintenance intervals.
When the engine is new, for example directly after purchasing the vehicle or after replacing the engine.
If low quality oil or oil of an inappropriate viscosity is used.
When driving at high engine speed or with a heavy load, (when towing, or), when driving while accelerating or decelerating frequently.
When leaving the idling for a long time, or when driving frequently through heavy traffic.
When judging the amount of oil consumption, keep in mind that the oil may have become diluted, making it difficult to judge the true level accurately.
ПРОВЕРЬТЕ, НЕТ ЛИ УТЕЧЕК МАСЛА
Запустите двигатель. Убедитесь, что утечки масла отсутствуют в узлах, на которых выполнялись работы.
УСТАНОВИТЕ ЗАЩИТУ КАРТЕРА ДВИГАТЕЛЯ № 2
Установите защиту картера двигателя № 2 и закрепите ее 2 болтами.
| 29 Н*м | 296 кгс*см | 21 фунт-сила-фут |
УСТАНОВИТЕ ЗАЩИТУ КАРТЕРА ДВИГАТЕЛЯ № 1 В СБОРЕ
Закрепите защиту картера двигателя № 1 в сборе 10 болтами.
| 29 Н*м | 296 кгс*см | 21 фунт-сила-фут |
УСТАНОВИТЕ БРЫЗГОВИК ЛЕВОГО ПЕРЕДНЕГО КРЫЛА В СБОРЕ
Вставьте фиксатор, чтобы закрепить брызговик левого переднего крыла в сборе.
Вверните 3 болта и 2 винта.
УСТАНОВИТЕ БРЫЗГОВИК ПРАВОГО ПЕРЕДНЕГО КРЫЛА В СБОРЕ
Порядок выполнения работ такой же, как для левой стороны.