ВОЗДУШНЫЙ НАГНЕТАТЕЛЬ УСТАНОВКА

INSTALL AIR PUMP

1. 

   Text in Illustration

   *1	Insulator
   *2	Air Pump
   *3	Air Pump Bracket
   *a	Top

   Install the 3 insulators to the air pump.

2. Attach the 2 wire harness clamps to the air pump bracket.

INSTALL NO. 1 AIR INJECTION SYSTEM HOSE

1. 

   Text in Illustration

   *1	No. 1 Air Injection System Hose
   *2	Protrusion
   *3	Air Pump Assembly

   Install the No. 1 air injection system hose to the air pump assembly.

   Tech Tips

   Push the No. 1 air injection system hose onto the air pump assembly until it contacts the protrusion as shown in the illustration.

INSTALL AIR PUMP INLET

1. 

   Text in Illustration

   *1	Air Pump Inlet
   *2	Stopper
   *3	No. 1 Air Injection System Hose

   Install the air pump inlet to the No. 1 air injection system hose.

   Tech Tips

   Insert the air pump inlet until its stopper contacts the No. 1 air injection system hose as shown in the illustration.

2. Install the 2 bolts and tighten them in the order shown in the illustration.

   Torque:

   8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

INSTALL AIR PUMP ASSEMBLY

1. 

   Text in Illustration

   *1

   Claw

   Attach the claw of the air pump bracket to the elongated hole in the body to position the air pump bracket.

2. Install the 2 bolts and 2 nuts and tighten them in the order shown in the illustration.

   Torque:

   18 N*m  { 184 kgf*cm, 13 ft.*lbf }

3. 

   Text in Illustration

   *1	Wire Harness
   *2	Paint Mark
   *3	Clamp

   Connect the wire harness to the clamp at the location shown in the illustration.

4. Attach the connector clamp to the bracket.

5. Connect the connector.

INSTALL NO. 3 AIR INJECTION SYSTEM HOSE

Text in Illustration

*1	Clamp A	*2	Clamp B
*3	Paint Mark	*4	Protector
*5	No. 3 Air Injection System Hose	*6	Wire Harness
*7	Protrusion	*8	Air Pump Assembly
*a	Top	*b	Front

1. Inside front fender RH:

   
   

   1. Connect the No. 3 air injection system hose to the air pump assembly at the location shown in the illustration.

      Tech Tips

      Align the paint mark of the No. 3 air injection system hose with the protrusion of the air pump assembly.

   2. Attach clamp A to the air pump bracket.

2. Inside engine room:

   
   

   1. Connect the No. 3 air injection system hose to the air tube at the location shown in the illustration.

   2. Align the bottom edge of the protector of the No. 3 air injection system hose with clamp B and attach the clamp.

INSTALL FRONT FENDER LINER RH

1. Install the fender liner with the 5 clips.

2. Using a T30 "TORX" socket, install the 3 screws.

3. Connect the liner to the front bumper cover with the screw.

INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

1. Push in the clip indicated by the arrow in the illustration to install the fender splash shield.

2. Install the 3 bolts and 2 screws.