Click here

ДАТЧИК УРОВНЯ ТОПЛИВА В СБОРЕ (для расширительного топливного бачка) СНЯТИЕ

Click here
Click here
  1. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    • w/ Navigation System:

      After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  2. Click here

    REMOVE REAR NO. 1 SEAT ASSEMBLY AND REAR NO. 2 SEAT ASSEMBLY

    (Click here)

  3. Click here

    REMOVE REAR FLOOR MAT ASSEMBLY


    1. Detach the 5 clips and fold back the floor mat toward the front of the vehicle.

      Tip:

      Fold back the floor mat so that the rear No. 7 air duct can be removed.

  4. Click here

    REMOVE REAR NO. 7 AIR DUCT


    1. A01ER8T

      Detach the 4 clips and remove the air duct.

  5. Click here

    REMOVE REAR FLOOR SERVICE HOLE COVER

  6. Click here

    REMOVE FUEL SENDER GAUGE ASSEMBLY


    1. A01EOMR

      Disconnect the sender gauge connector.

    2. Remove the 5 screws and sender gauge.

      Note:

      Be careful not to bend the arm of the fuel sender gauge.

    3. Remove the gasket from the sender gauge.