ТОПЛИВНЫЙ НАСОС ПОВТОРНАЯ СБОРКА

Click here

Note: Do not disconnect the hoses indicated in the illustration.

Click here

Click here
INSTALL NO. 1 FUEL SUCTION SUPPORT
1. Attach the 2 claws to the claw holes to install the fuel suction support.

INSTALL FUEL MAIN VALVE ASSEMBLY

Apply a light coat of gasoline to 2 new O-rings, and install them to the fuel main valve.

Table 1. Text in Illustration

*1 New O-Ring

A01ENRWE02

Install the fuel main valve to the fuel filter case.

Table 2. Text in Illustration
*1	Fuel Filter Case
*2	O-Ring

Note:

Make sure the O-rings are not cut or pinched during the installation.

INSTALL FUEL PUMP

Connect the fuel pump wire harness connector to the fuel pump.

A01ENPRE02

Apply a light coat of gasoline to a new O-ring. Then install the O-ring and spacer to the fuel pump.

Table 3. Text in Illustration
*1	O-Ring
*2	Spacer

Attach the 5 claws to the claw holes and install the fuel pump to the fuel filter case.

Click here
INSTALL NO. 1 FUEL SUB-TANK

Note:
Make sure that the fuel tube passes into the section marked by the circle.

Table 4. Text in Illustration

*1 Fuel Tube
1. Attach the 3 claws to the claw holes and install the No. 1 fuel sub-tank.
2. Attach the 3 claws to the claw holes.
3. Connect the jet pump (labeled B) to the No. 1 fuel sub-tank.
  
  Table 5. Text in Illustration
  
  *1 Jet Pump
  1. Attach the claw on the end of the tube to the claw hole.
4. Connect the jet pump (labeled A) to the No. 1 fuel sub-tank.
5. Connect the fuel pump connector.
Click here
INSTALL FUEL SENDER GAUGE ASSEMBLY
1. Установите датчик уровня топлива в расширительный топливный бачок. Затем сдвиньте датчик уровня топлива вниз и установите его.
  
  Table 6. Обозначения на рисунке
  
  Сдвиг
2. Подсоедините разъем датчика уровня топлива.