Click here

ТОПЛИВНАЯ ФОРСУНКА ПРОВЕРКА

Click here
Click here Click here
  1. Click here

    INSPECT FUEL INJECTOR ASSEMBLY


    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 2 20°C (68°F) 11.6 to 12.4 Ω

      If the result is not as specified, replace the fuel injector assembly.

    2. Inspect the injection volume.

      CAUTION:

      This test involves high-pressure fuel and electricity. Take all precautions regarding safe handling of both the fuel and the electricity. Perform this test in a safe area and avoid any sparks or flames. Do not smoke.


      1. A01ENJ3E04

        Connect SST to the fuel pipe.

        09268-31014 09268-41500 09268-41700 95336-08070
        Table 1. Text in Illustration
        *1 SST (Hose)
        *2 SST (Hose Band)
        *3 SST (Fuel Tube Connector)
        *4 Fuel Pipe
      2. A01EOGLE04

        Install the O-ring to the fuel injector.

      3. Install SST and the tube to the fuel injector.

        09268-31014 09268-41300 09268-41600 09268-41700 95336-08070
        Table 2. Text in Illustration
        *1 SST (Hose)
        *2 SST (Hose Band)
        *3 SST (Adapter)
        *4 O-ring
        *5 Vinyl Tube
        *6 SST (Clamp)
      4. A01EN2DE01

        Pass SST (tie band) through the loop on the handle of SST (clamp) to secure SST (clamp) to SST (adapter).

        09268-31014 09268-41800
        Table 3. Text in Illustration
        *1 Lock
        *2 Tie Band
        Note:

        • As SST (tie band) does not completely prevent SST (clamp) from becoming loose, do not subject the parts to any impacts while using them.

        • Before using SST (tie band), make sure that there is no deterioration, damage or cracks. If there are any abnormalities, replace SST.

        Tip:

        When removing SST (tie band), disengage the lock.

      5. Check that SST (clamp) and SST (adapter) cannot be easily separated.

      6. Install a vinyl tube to the injector.

      7. Put the injector into a graduated cylinder.

        CAUTION:

        Install a strong rubber tube to the injector to prevent gasoline from splashing.

      8. Operate the fuel pump (Click here).

      9. A01ENXPE09

        Connect SST (EFI inspection wire I) to the injector and battery for 15 seconds, and then measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.

        09842-30090
        Standard injection volume
        82 to 99 cc (5.0 to 6.0 cu in.) per 15 seconds
        Difference between each injector
        17 cc (1.0 cu in.) or less
        Table 4. Text in Illustration
        *1 SST (EFI Inspection Wire I)
        A01EO1M Connect
        Note:

        • Make sure that SST (EFI inspection wire I) is securely connected.

        • Always turn the voltage on and off on the battery side, not the fuel pump side.

        If the injection volume is not as specified, replace the injector assembly.

    3. Check for leakage.


      1. In the condition above, disconnect the tester probes of SST (wire) from the battery and check for fuel leakage from the injector.

        Standard fuel leakage
        1 drop or less in 12 minutes