ГИДРАВЛИЧЕСКИЙ КЛАПАН ИЗМЕНЕНИЯ ФАЗ СНЯТИЕ


  1. REMOVE ENGINE ROOM SIDE COVER LH


    1. Освободите 7 фиксаторов и снимите левую боковую крышку моторного отсека.

      A01EN5SE01

  2. REMOVE ENGINE ROOM SIDE COVER RH


    1. Снимите 7 фиксаторов и правую боковую крышку моторного отсека.

      A01EPFTE01

  3. REMOVE UPPER RADIATOR SUPPORT SEAL


    1. A01ENLH

      Освободите 3 фиксатора и снимите верхнее уплотнение кронштейна радиатора.

  4. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A01EO82E01
      Обозначения на рисунке
      *1 Уплотнительная шайба
      *2 Колпачок
      *3 Крюк
      *4 Кронштейн

      Поднимите переднюю часть декоративной крышки V-образного двигателя, чтобы открепить 3 штифта. Затем снимите 2 крюка декоративной крышки V-образного двигателя с кронштейна, чтобы снять декоративную крышку V-образного двигателя.

  5. REMOVE AIR CLEANER CAP AND HOSE


    1. A01ERFI

      Disconnect the No. 2 PCV hose and No. 1 air hose.

    2. Disconnect the mass air flow meter connector and detach the clamp.

    3. Detach the 4 clamps.

    4. Loosen the hose clamp and remove the air cleaner cap and hose.

  6. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Exhaust Side of Bank 1)


    1. A01ENHH

      Disconnect the camshaft timing oil control valve connector.

    2. Remove the bolt and camshaft timing oil control valve.

    3. Remove the O-ring from the camshaft timing oil control valve.

  7. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Intake Side of Bank 1)


    1. A01EO4Y

      Disconnect the camshaft timing oil control valve connector.

    2. Remove the bolt and camshaft timing oil control valve.

    3. Remove the O-ring from the camshaft timing oil control valve.

  8. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Intake Side of Bank 2)


    1. A01ENVU

      Disconnect the throttle body connector and detach the clamp.

    2. A01EQP0

      Remove the hose clamp, bolt and air pipe.

    3. A01ES8U

      Disconnect the camshaft timing oil control valve connector.

    4. Remove the bolt and camshaft timing oil control valve.

    5. Remove the O-ring from the camshaft timing oil control valve.

  9. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Exhaust Side of Bank 2)


    1. A01EQ0K

      Disconnect the camshaft timing oil control valve connector.

    2. Remove the bolt and camshaft timing oil control valve.

    3. Remove the O-ring from the camshaft timing oil control valve.