HEADLIGHT ASSEMBLY DISASSEMBLY


  1. REMOVE NO. 1 HEADLIGHT BACK COVER


    1. A0161G4

      Remove the No. 1 headlight back cover as shown in the illustration.

  2. REMOVE NO. 1 HEADLIGHT COVER GASKET


    1. Remove the No. 1 headlight cover gasket.

      Note

      After the No. 1 headlight cover gasket is removed, be sure to replace it with a new one. Failure to do this may cause water ingress.

  3. REMOVE DISCHARGE HEADLIGHT BULB


    1. A0160S2

      Separate the light control ECU socket as shown in the illustration.

    2. A0162TPE01

      Release the set spring and remove the discharge headlight bulb as shown in the illustration.

  4. REMOVE NO. 2 HEADLIGHT BACK COVER


    1. A01608F

      Remove the No. 2 headlight back cover as shown in the illustration.

  5. REMOVE NO. 2 HEADLIGHT COVER GASKET


    1. Remove the No. 2 headlight cover gasket.

      Note

      After the No. 2 headlight cover gasket is removed, be sure to replace it with a new one. Failure to do this may cause water ingress.

  6. REMOVE NO. 2 HEADLIGHT BULB


    1. A0160R7

      Disconnect the connector.

    2. Remove the No. 2 headlight bulb as shown in the illustration.

  7. REMOVE CLEARANCE LIGHT BULB


    1. A01622D

      Turn the clearance light bulb and the clearance light socket in the direction indicated by the arrow in the illustration and remove them as a unit.

    2. Remove the clearance light bulb from the clearance light socket.

  8. REMOVE CLEARANCE LIGHT SOCKET


    1. Disconnect the connector and remove the clearance light socket.

  9. REMOVE FRONT TURN SIGNAL LIGHT BULB


    1. A01600Q

      Turn the front turn signal light bulb and the headlight cord in the direction indicated by the arrow and remove them as a unit.

    2. Remove the front turn signal light bulb from the headlight cord.

  10. REMOVE FRONT BUMPER SIDE SUPPORT


    1. A0160R1

      Remove the 3 screws and front bumper side support.

  11. REMOVE HEADLIGHT LEVELING MOTOR


    1. A0160JZ

      Disconnect the connector.

    2. Align the notches of the headlight leveling motor and the housing, and pull out the headlight leveling motor slightly.

      Tech Tips

      For the headlight leveling motor RH, rotate it symmetrical to the directional arrow shown in the illustration.

    3. A0160V2

      Lower the tip of the headlight leveling motor to disengage it from the reflector and remove the headlight leveling motor.

  12. REMOVE HEADLIGHT LEVELING MOTOR BASE PACKING


    1. Remove the headlight leveling motor base packing.

      Note

      After the headlight leveling motor base packing is removed, be sure to replace it with a new one. Failure to do this may cause water ingress.