RAIN SENSOR INSTALLATION


  1. INSTALL RAIN SENSOR TAPE


    1. A0160SZE01

      Peel off the releasing sheet (yellow side) and attach the rain sensor tape on the position indicated in the illustration (the sensor part of the rain sensor) while pushing out air bubbles with fingers.

    2. Peel off the releasing sheet (white side).

      Note


      • When reusing the rain sensor, clean up dirt on the sensor part with a piece of cloth, etc.

      • Do not touch the sensor tape surface directly with fingers.

      Area Measurement
      A 45.5 mm (1.791 in.)
      B 24.7 mm (0.972 in.)
      C 10.0 mm (0.393 in.)
      D 9.8 mm (0.385 in.)

  2. INSTALL RAIN SENSOR


    1. Connect the connector.

    2. A015YV3

      Engage the claw as shown in the illustration to set the position.

    3. Gradually attach the rain sensor to the glass surface to prevent air bubbles from forming in between them.

    4. A0160Q6E01

      Push in the stopper.

      Note


      • Do not touch the sensor tape surface and the glass surface directly with fingers.

      • Clean up dirt on the glass with a piece of cloth, etc.

      • After installing the rain sensor, there should be no air bubbles between the windshield glass and the rain sensor tape.