REAR POWER WINDOW SWITCH INSPECTION


  1. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (for Rear LH)


    1. A016060E03

      Check the switch function.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        2 (U) - 5 (E) Auto up or up position Below 1 Ω
        4 (A) - 5 (E) Auto up or auto down position Below 1 Ω
        10 (D) - 5 (E) Auto down or down position Below 1 Ω
        2 (U) - 5 (E) Free 10 kΩ or higher
        4 (A) - 5 (E) Free 10 kΩ or higher
        10 (D) - 5 (E) Free 10 kΩ or higher

        If the result is not as specified, replace the rear power window regulator switch assembly (for rear LH side).

    2. A016060E11

      Check that the LED illuminates.


      1. Apply battery voltage to the rear power window regulator switch assembly and check that the LED illuminates.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → 8 (LED)

        Battery negative (-) → 5 (E)

        		 LED illuminates

        If the result is not as specified, replace the rear power window regulator switch assembly (for rear LH side).

  2. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (for Rear RH)


    1. A016060E02

      Check the switch function.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        2 (U) - 5 (E) Auto up or up position Below 1 Ω
        4 (A) - 5 (E) Auto up or auto down position Below 1 Ω
        10 (D) - 5 (E) Auto down or down position Below 1 Ω
        2 (U) - 5 (E) Free 10 kΩ or higher
        4 (A) - 5 (E) Free 10 kΩ or higher
        10 (D) - 5 (E) Free 10 kΩ or higher

        If the result is not as specified, replace the rear power window regulator switch assembly (for rear RH side).

    2. A016060E12

      Check that the LED illuminates.


      1. Apply battery voltage to the rear power window regulator switch assembly and check that the LED illuminates.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → 8 (LED)

        Battery negative (-) → 5 (E)

        		 LED illuminates

        If the result is not as specified, replace the rear power window regulator switch assembly (for rear RH side).