POWER WINDOW CONTROL SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

Tech Tips


  • Use the following procedure to troubleshoot the power window control system.

  • *: Using the intelligent tester.


  1. VEHICLE BROUGHT TO WORKSHOP


    NEXT

  2. CUSTOMER PROBLEM ANALYSIS


    • In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.

    • Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.

    • The following 5 items are important points in the problem analysis:

      What Vehicle model, system name
      When Date, time, occurrence frequency
      Where Road conditions
      Under what conditions? Driving conditions, weather conditions
      How did it happen? Problem symptoms

    NEXT

  3. PRE-CHECK


    1. Measure the battery voltage.

      Standard Voltage
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

    2. Check the fuses and relays.

    3. Check the connector connections and terminals to make sure that there are no abnormalities such as loose connections, deformation, etc.


      NEXT

  4. INSPECT COMMUNICATION FUNCTION OF MULTIPLEX COMMUNICATION SYSTEM (BEAN)*


    1. Use the intelligent tester to check if the multiplex communication system (BEAN) is functioning normally Click here.

      Result
      Result Proceed to
      No DTCs output A
      DTCs output B

      B

      GO TO MULTIPLEX COMMUNICATION SYSTEM (BEAN) Click here

      A

  5. PROBLEM SYMPTOMS TABLE


    1. Refer to Problem Symptoms Table Click here.

      Result
      Result Proceed to
      Fault is not listed in problem symptoms table A
      Fault is listed in problem symptoms table B

      B

      Go to step 7
      A

  6. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Operation Check Click here

    2. Data List / Active Test Click here

    3. Terminals of ECU Click here


      NEXT

  7. REPAIR OR REPLACE


    NEXT

  8. RESET POWER WINDOW MOTOR


    1. If any of the multiplex network master switch assembly or power window regulator switch assembly LEDs is blinking, reset the power window regulator motor assembly Click here.


      NEXT

  9. CONFIRMATION TEST


    NEXT
    END