FRONT SEAT OUTER BELT ASSEMBLY INSTALLATION


  1. INSPECT FRONT SEAT OUTER BELT ASSEMBLY


    1. A01603LE01

      Check the degree of tilt when the ELR begins to lock.


      1. Check that the belt does not lock at less than 15 degrees of tilt in any direction but locks at over 45 degrees of tilt while gently pulling the belt.

        Note

        Do not disassemble the retractor.

  2. INSTALL FRONT SEAT OUTER BELT ASSEMBLY


    1. A0162AJ

      Temporarily install the front seat outer belt assembly with the 2 bolts.

    2. Fully tighten the upper side bolt first, then the lower side bolt to install the front seat outer belt assembly.

      Torque:
      For upper bolt
      7.5 N*m  { 77 kgf*cm, 66 in.*lbf }
      For lower bolt
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }
    3. A01628O

      Connect the pretensioner connector and lock the locking button as shown in the illustration.

      Note

      Securely lock the locking button.

    4. Connect the connectors.

    5. A0160BR

      Install the shoulder anchor of the front seat outer belt assembly with the nut.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  3. INSTALL CENTER PILLAR GARNISH


    1. A0162U8

      Engage the 2 claws and install the center pillar garnish LH.

    2. Install the 2 screws.

  4. INSTALL LOWER CENTER PILLAR GARNISH


    1. A01604OE01

      Engage the 5 clips and 3 claws, and install the lower center pillar garnish LH.

  5. INSTALL REAR DOOR SCUFF PLATE


    1. A016266

      Engage the 2 clips.

    2. A015YIJ

      Engage the 5 claws and install the rear door scuff plate LH.

  6. INSTALL FRONT DOOR SCUFF PLATE


    1. A015ZPR

      Engage the 4 clips.

    2. A0161H2

      Engage the 7 claws and install the front door scuff plate LH.

  7. CONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. A015Z32

      Install the front seat outer belt assembly LH with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  8. INSTALL LAP BELT OUTER ANCHOR COVER


    1. A0162EC

      Engage the 2 claws and install the lap belt outer anchor cover as shown in the illustration.

      Tech Tips

      Use the same procedure to install the cover on the other side.

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    Some systems need to be initialized after the cable is reconnected Click here.

  10. INSPECT SRS WARNING LIGHT

    Inspect the SRS warning light Click here.