PRE-CRASH SAFETY SYSTEM, Diagnostic DTC:B2002

DTC Code DTC Name
B2002 Open in Seat Belt Motor RH Circuit

DESCRIPTION

The seat belt control ECU receives information from the distance control ECU using CAN communication and tightens the seat by operating the motor in the front seat outer belt assembly RH.

CAUTION:

The pretensioner is built into the front seat outer belt assembly RH. Be sure to follow the correct inspection procedure, as failure to follow the correct procedure (such as inspection of incorrect connectors) may deploy the pretensioner.

DTC No. DTC Detection Condition Trouble Area
B2002

  • Open in the seat belt motor RH circuit continues for 1 second or more

  • Front seat outer assembly RH

  • Wire harness (seat belt control ECU - front seat outer belt assembly RH)

  • Seat belt control ECU

WIRING DIAGRAM

A01606CE03

INSPECTION PROCEDURE

Note

When the seat belt control ECU is replaced with a new one, Initialization must be performed Click here.

PROCEDURE


  1. INSPECT FRONT SEAT OUTER BELT ASSEMBLY RH


    1. A015YKBE05

      Disconnect the P8 connector of the front seat outer belt assembly RH.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      P8-1 - P8-2 Always Below 1 MΩ

    NG

    REPLACE FRONT SEAT OUTER BELT ASSEMBLY RH Click here

    OK

  2. CHECK HARNESS AND CONNECTOR (FRONT SEAT OUTER BELT ASSEMBLY RH - SEAT BELT CONTROL ECU)


    1. Disconnect the cable from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    2. A01629QE01

      Disconnect the Q38 connector of the seat belt control ECU.

    3. Using SST, connect P8-1 and P8-2 of the wire harness connector for the front seat outer belt assembly RH.

      Note

      Do not forcibly insert SST into the terminals of the connector.

      SST
      09843-18040

    4. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      Q38-1 (MOR+) - Q38-10 (MOR-) Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE SEAT BELT CONTROL ECU Click here