REAR AIRBAG SENSOR INSTALLATION


  1. INSTALL REAR AIRBAG SENSOR


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A0162O5E01

      Install the rear airbag sensor with the bolt and pin.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

      • When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

      • Make sure that the pin is securely inserted into the body hole.

      • Tighten the bolt while holding the rear airbag sensor because the rear airbag sensor pin (stopper) is easily damaged.

    4. Connect the connector to the rear airbag sensor.

      Note

      When connecting the airbag connector, take care not to damage the airbag wire harness.

    5. Check that there is no looseness in the installation parts of the rear airbag sensor.

  2. INSTALL REAR SEAT SIDE GARNISH


    1. A0163A2

      Engage the 5 claws and install the rear seat side garnish LH.

  3. INSTALL REAR DOOR SCUFF PLATE


    1. A016266

      Engage the 2 clips.

    2. A015YIJ

      Engage the 5 claws and install the rear door scuff plate LH.

  4. INSTALL REAR SEATBACK ASSEMBLY


    1. Place the seatback in the cabin.

      Note

      Be careful not to damage the vehicle body.

    2. A0163EJ

      Engage the 3 hooks.

    3. Install the rear seatback assembly with the 4 bolts.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }
    4. A015YIY

      Pass the seat belt through the rear seat shoulder belt guide RH.

    5. Engage the 2 claws and close the 2 caps of the rear seat shoulder belt guide RH.

    6. A0160LI

      Pass the seat belt through the rear seat shoulder belt guide LH.

    7. Engage the 2 claws and close the 2 caps of the rear seat shoulder belt guide LH.

  5. INSTALL REAR SEAT CUSHION ASSEMBLY


    1. A0162ZH

      Engage the 2 rear hooks of the seat cushion to the child restraint seat anchor bracket.

    2. Engage the 2 front hooks of the seat cushion to the vehicle body.

    3. Confirm that the seat cushion is firmly installed.

      Note

      When installing the seat cushion, make sure the seat belt buckle is not under the seat cushion.

  6. INSTALL REAR SEAT HEADREST ASSEMBLY LH

  7. INSTALL REAR SEAT HEADREST ASSEMBLY RH

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  9. INSPECT SRS WARNING LIGHT


    1. Inspect the SRS warning light Click here.