CURTAIN SHIELD AIRBAG ASSEMBLY REMOVAL

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

  2. REMOVE ROOF HEADLINING ASSEMBLY

    Tech Tips

    Refer to the procedure up to Remove Roof Headlining Assembly Click here.

  3. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Disconnect the curtain shield airbag connector.

      Note

      When disconnecting the airbag connector, take care not to damage the airbag wire harness.

    4. Remove the 9 bolts and 2 clamps.

      A01632I

      Note

      Do not reuse the bolt.

    5. Disengage the 7 hooks and remove the curtain shield airbag assembly.

      A0161R5