AIRBAG SYSTEM SRS Warning Light does not Come ON

DESCRIPTION

The SRS warning light is located on the combination meter assembly.

When the SRS is normal, the SRS warning light comes on for approximately 6 seconds after the engine switch is turned from off to on (IG), and then goes off automatically.

If there is a malfunction in the SRS, the SRS warning light comes on to inform the driver of a problem.

When terminals TC and CG of the DLC3 are connected, the DTC is displayed by blinking of the SRS warning light.

The SRS is equipped with a voltage-increase circuit (DC-DC converter) in the center airbag sensor assembly in case the source voltage drops.

When the battery voltage drops, the voltage-increase circuit (DC-DC converter) functions to increase the voltage of the SRS to normal voltage.

A malfunction in this circuit is not recorded in the center airbag sensor assembly. The SRS warning light automatically goes off when the source voltage returns to normal.

The signal to illuminate the SRS warning light is transmitted from the center airbag sensor assembly to the combination meter assembly through the CAN communication system and multiplex communication system.

WIRING DIAGRAM

A015YLRE02

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK BATTERY VOLTAGE


    1. Measure the voltage of the battery.

      Standard Voltage
      11 to 14 V

    NG

    INSPECT CHARGING SYSTEM AND BATTERY Click here

    OK

  2. CHECK CONNECTOR


    1. Turn the engine switch off.

    2. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

    3. Check that the connector is properly connected to the combination meter assembly.

      OK
      The connector is properly connected.

      Tech Tips

      If the connector is not connected securely, reconnect the connector and proceed to the next inspection.

    4. Disconnect the connector from the combination meter assembly.

    5. Check that the terminal of the connector is not damaged.

      OK
      The terminal is not deformed or damaged.

    NG

    REPLACE WIRE HARNESS

    OK

  3. CHECK WIRE HARNESS (COMBINATION METER ASSEMBLY - BODY GROUND)


    1. A0163AGE04

      Connect the cable to the negative (-) battery terminal.

    2. Turn the engine switch on (IG).

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      J34-24 (B) - Body ground Always 11 to 14 V
      J34-12 (IG+) - Body ground Engine switch on (IG) 11 to 14 V

    4. Turn the engine switch off.

    5. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      J34-13 (ES) - Body ground Always Below 1 Ω

    NG

    REPLACE WIRE HARNESS

    OK

  4. CHECK SRS WARNING LIGHT


    1. Connect the connector to the combination meter assembly.

    2. Disconnect the connector from the center airbag sensor assembly.

    3. Connect the cable to the negative (-) battery terminal.

    4. Turn the engine switch on (IG).

    5. Check the SRS warning light condition.

      OK
      After the primary check period, the SRS warning light goes off for approximately 10 seconds and remains on.

      Tech Tips

      The primary check period is approximately 6 seconds after the engine switch is turned on (IG).


    NG

    REPLACE COMBINATION METER ASSEMBLY Click here

    OK

    REPLACE CENTER AIRBAG SENSOR ASSEMBLY Click here