METER / GAUGE SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Tech Tips

    Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Warm up the engine.

    2. Turn the engine switch off.

    3. Connect the intelligent tester to the DLC3.

    4. Turn the engine switch on (IG).

    5. Turn the intelligent tester on.

    6. Enter the following menus:


      1. for Combination Meter: Body / Combination Meter / Data List.

      2. for ABS/TRC/VSC: Chassis / ABS/VSC/TRC / Data List.

      3. for Engine and ECT: Powertrain / Engine and ECT / Data List.

    7. Check values by referring to the table below.

      Combination Meter
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Vehicle Speed Meter Vehicle speed/Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) Almost same as actual vehicle speed (When driving) -
      Engine Rpm Engine speed/Min.: 0 rpm, Max.: 12750 rpm Almost same at the meter rpm (When engine is running) -
      Fuel Input Fuel input signal/Min.: 0, Max.: 255 Fuel gauge indicates (E): 6.8 Unit: Liters
      Fuel gauge indicates (1/2): 32.1
      Fuel gauge indicates (F): 56.3
      Light Control Rheostat Light Control Rheostat/Min.: 0%, Max.: 100% Turn the light control rheostat knob fully counterclockwise (0%) -
      Turn the light control rheostat knob fully clockwise (100%) -
      ODO/TRIP Change SW ODO/TRIP switch is OFF or ON OFF: Switch is released -
      ON: Switch is pushed -
      Tail Cancel SW Tail cancel switch is OFF or ON OFF: The light control rheostat knob position is except below -
      ON: Turn the light control rheostat knob fully clockwise (Tail cancel switch is ON) -
      Key Remind Volume The volume of the key reminder warning buzzer is displayed Volume of the key reminder warning buzzer: Fast, Normal, Slow -
      Key Remind Sound The cycle of the key reminder warning buzzer is displayed Cycle of the key reminder warning buzzer: Large, Medium, Small -
      ABS/VSC/TRC
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      FR Wheel Speed Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Almost same as actual vehicle speed (When driving) -
      FL Wheel Speed Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Almost same as actual vehicle speed (When driving) -
      RR Wheel Speed Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Almost same as actual vehicle speed (When driving) -
      RL Wheel Speed Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Almost same as actual vehicle speed (When driving) -
      Vehicle Speed Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Almost same as actual vehicle speed (When driving) -
      Engine and ECT
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Engine Speed Vehicle speed/Min.: 0 rpm, Max.: 16383.75 rpm Almost same as actual engine speed (When engine running) -
      Coolant Temp Engine coolant temperature: Min.: -40°C (-40°F), Max: 140°C (284°F) 80 to 100°C (176 to 212°F): After warming up
      • If -40°C (-40°F): sensor circuit is open

      • If 140°C (284°F) or more: sensor circuit is short

  2. ACTIVE TEST

    Tech Tips

    Using the intelligent tester to perform Active Tests allows the relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in trouble shooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus:


      1. for Combination Meter: Body / Combination Meter / Active Test.

      2. for Body: Body / Body (Main Body ECU RH) / Active Test.

    5. Check each operation by referring to the table below.

      Combination Meter
      Tester Display Test Part Control Range Diagnostic Note
      Speed Meter Operation Speedometer 0, 40, 80, 120 mph*1 Confirm that the vehicle is stopped, engine idling
      0, 40, 80, 120, 160, 200, 240 km/h*2
      Tacho Meter Operation Tachometer 0, 1000, 2000, 3000, 4000, 5000*6, 6000*6, 7000*6 (rpm) Confirm that the vehicle is stopped, engine idling
      Fuel Meter Operation Fuel receiver gauge EMPTY, 1/2, FULL Confirm that the vehicle is stopped, engine idling
      Water Temperature Meter Operation Engine coolant temperature receiver gauge Low, Normal, High Confirm that the vehicle is stopped, engine idling
      Indicat. Lamp Fuel Low fuel warning light OFF or ON Confirm that the vehicle is stopped, engine idling
      Indicat. Lamp Door Open door warning light OFF or ON Confirm that the vehicle is stopped, engine idling
      Front Passenger Side Seat Belt Front passenger side seat belt warning light OFF or ON Confirm that the vehicle is stopped, engine idling
      Driver Side Seat Belt Driver side seat belt warning light OFF or ON Confirm that the vehicle is stopped, engine idling
      Indicat. Lamp Charge Charge warning light OFF or ON Confirm that the vehicle is stopped, engine idling
      Indicat. Lamp Brake Brake warning light OFF or ON Confirm that the vehicle is stopped, engine idling
      Indicat. Lamp Tail Tail indicator light OFF or ON Confirm that the vehicle is stopped, engine idling
      Indicat. Lamp Cruise Cruise indicator light OFF or ON Confirm that the vehicle is stopped, engine idling
      Indicat. Lamp ECT SPORT*3 Sport indicator light OFF or ON Confirm that the vehicle is stopped, engine idling
      Indicat. Lamp ECT SNOW*3 Snow indicator light OFF or ON Confirm that the vehicle is stopped, engine idling
      Indicat. Lamp Airbag Airbag warning light OFF or ON Confirm that the vehicle is stopped, engine idling
      Indicat. Lamp Beam Hi-beam indicator light OFF or ON Confirm that the vehicle is stopped, engine idling
      Indicat. Lamp ABS ABS warning light OFF or ON Confirm that the vehicle is stopped, engine idling
      Indicat. Lamp TRAC(TRC) OFF TRC OFF indicator light OFF or ON Confirm that the vehicle is stopped, engine idling
      Indicat. Lamp Slip Slip indicator light OFF or ON Confirm that the vehicle is stopped, engine idling
      Indicat. ODO/TRIP Display ODO/TRIP display OFF or ON Confirm that the vehicle is stopped, engine idling
      A/T Oil Temperature Operation A/T oil temperature warning light OFF or ON Confirm that the vehicle is stopped, engine idling
      Indicat. Lamp Fr FOG Front fog indicator light OFF or ON Confirm that the vehicle is stopped, engine idling
      Indicat. Lamp Rr FOG Rear fog indicator light OFF or ON Confirm that the vehicle is stopped, engine idling
      Indicat. Lamp VSC OFF VSC OFF indicator light OFF or ON Confirm that the vehicle is stopped, engine idling
      Key Remained Buzzer Key reminder buzzer OFF or ON Confirm that the vehicle is stopped, engine idling
      Light Remained Buzzer Light reminder buzzer OFF or ON Confirm that the vehicle is stopped, engine idling
      Seat Belt Buzzer Seat belt warning buzzer OFF or ON Confirm that the vehicle is stopped, engine idling
      Reverse Buzzer Reverse buzzer OFF or ON Confirm that the vehicle is stopped, engine idling
      Shift Down Reject Buzzer Shift down reject buzzer OFF or ON Confirm that the vehicle is stopped, engine idling
      Warning Buzzer Warning buzzer OFF or ON Confirm that the vehicle is stopped, engine idling
      Indicat. A/T LCD A/T shift indicator light OFF or ON Confirm that the vehicle is stopped, engine idling
      Indicat. EPS EPS warning light OFF or ON Confirm that the vehicle is stopped, engine idling
      Master Warning Master caution indicator light OFF or ON Confirm that the vehicle is stopped, engine idling
      Indicat. INTUITIVE P/A LCD*4 All the dot in the Lexus parking assist-sensor display OFF or ON Confirm that the vehicle is stopped, engine idling
      Multi-display All the dots in the multi-information display OFF or ON Confirm that the vehicle is stopped, engine idling
      Indicat. Precrash*5 Precrash indicator light OFF or ON Confirm that the vehicle is stopped, engine idling
      Coolant Temp LCD All the dots of the coolant temperature LCD OFF or ON Confirm that the vehicle is stopped, engine idling
      Daytime Running Light OFF Indicator DRL off indicator light OFF or ON Confirm that the vehicle is stopped, engine idling
      Speedometer LCD All the segments of the speedometer LCD OFF or ON Confirm that the vehicle is stopped, engine idling

      • *1: for models with mph units

      • *2: for models with km/h units

      • *3: To select the ECT SPORT, or the ECT SNOW in the intelligent tester, the sport or the snow indicator light can be operated.

      • *4: w/ Lexus Parking Assist-sensor System

      • *5: w/ Pre-crash Safety System

      • *6: Revolution indicator also comes on when the item is selected.

      Body (Main Body ECU RH)
      Tester Display Test Part Control Range Diagnostic Note
      Dimmer Signal Dimmer signal OFF or ON OFF: The meter illumination (warning and indicator lights) will not dim even if the light control switch to the TAIL or HEAD position
      ON: The meter illumination (warning and indicator lights) dims when the light control switch to the TAIL or HEAD position