ENGINE HOOD COURTESY SWITCH REMOVAL


  1. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01638L

      Using a clip remover, remove the 9 clips and cool air intake duct seal.

  2. REMOVE RADIATOR GRILLE PROTECTOR


    1. A01623G

      Remove the 2 radiator grille protectors.

  3. REMOVE FRONT BUMPER ASSEMBLY


    1. A0162OR

      Using a screwdriver, turn the pins 90 degrees and remove the 2 pin hold clips.

      Tech Tips


      • Tape the screwdriver tip before use.

      • Use the same procedure for the RH side and LH side.

    2. A0162S2

      remove the screw.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    3. A0163H6E01

      Put protective tape around the front bumper assembly.

    4. Remove the 8 screws.

    5. A0161S5

      Using a clip remover, remove the 2 clips and screw.

    6. A01617S

      Disengage the 10 claws and disconnect the front bumper assembly as shown in the illustration.

    7. w/ LEXUS Parking Assist-Sensor system:


      1. Disconnect the ultrasonic sensor connector.

    8. Disconnect the headlight cleaner hose.

      Note

      Prepare a drain pan or a piece of cloth in case washer fluid leaks.

    9. Disconnect the 2 fog light connectors and remove the front bumper assembly.

  4. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)


    1. Disconnect the connector.

    2. A0163DZ

      Remove the 3 bolts and the millimeter wave radar sensor assembly.

  5. REMOVE LOW PITCHED HORN ASSEMBLY


    1. A015ZT9

      Disconnect the connector.

    2. Remove the bolt and the low pitched horn assembly.

  6. REMOVE HOOD LOCK CONTROL CABLE COVER


    1. A015YPE

      Remove the 3 screws.

    2. Disengage the clamp and remove the hood lock control cable cover.

  7. REMOVE HOOD LOCK NUT CAP


    1. A0161ZRE01

      Using a screwdriver, remove the hood lock nut cap as shown in the illustration.

      Tech Tips

      Tape the screwdriver tip before use.

  8. REMOVE ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY)


    1. A0161GB

      Remove the 2 bolts and hood lock nut.

    2. A0163A3

      Disconnect the hood lock control cable assembly.

    3. Disconnect the connector and remove the hood lock assembly.