REMOVE NO. 2 LUGGAGE COMPARTMENT TRIM COVER (w/ LEXUS Parking Assist-sensor System)
REMOVE DECK SIDE TRIM BOX LH (w/ LEXUS Parking Assist-sensor System)
REMOVE DECK SIDE TRIM BOX RH (w/ LEXUS Parking Assist-sensor System)
REMOVE ROPE HOOK ASSEMBLY (w/ LEXUS Parking Assist-sensor System)
Remove the 3 bolts and 3 rope hook assemblies.
REMOVE REAR LUGGAGE COMPARTMENT TRIM COVER (w/ LEXUS Parking Assist-sensor System)
Using a clip remover, remove the 3 clips.
Disengage the 4 clips and remove the rear luggage compartment trim cover.
REMOVE NO. 2 ROOM LIGHT ASSEMBLY (w/ LEXUS Parking Assist-sensor System)
Disengage the claw and disconnect the No. 2 room light assembly.
Disconnect the connector and remove the No. 2 room light assembly.
REMOVE ROPE HOOK (w/ LEXUS Parking Assist-sensor System)
Remove the 2 rope hooks.
REMOVE NO. 2 LUGGAGE COMPARTMENT TRIM HOOK (w/ LEXUS Parking Assist-sensor System)
Remove the 3 No. 2 luggage compartment trim hooks as shown in the illustration.
REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER (w/ LEXUS Parking Assist-sensor System)
Using a clip remover, remove the 2 clips.
Disengage the 4 claws and remove the front luggage compartment trim cover.
REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (w/ LEXUS Parking Assist-sensor System)
Remove the screw and No. 1 luggage compartment trim hook.
REMOVE SIDE LUGGAGE COMPARTMENT TRIM COVER (w/ LEXUS Parking Assist-sensor System)
Using a clip remover, remove the 3 clips and side luggage compartment trim cover.
REMOVE NO. 1 REAR BUMPER PLATE
Using a screwdriver, disengage the 2 claws and remove the No. 1 rear bumper plate.
Tech Tips
Tape the screwdriver tip before use.
Use the same procedure for the RH side and LH side.
REMOVE REAR BUMPER ASSEMBLY
w/ LEXUS Parking Assist-Sensor System:
Disconnect the No. 3 luggage room wire connector.
Put protective tape around the rear bumper assembly.
Using a clip remover, remove the 2 clips.
Remove the 6 screws and 2 rear bumper seal brackets.
Disengage the 6 claws and disconnect the rear bumper assembly as shown in the illustration.
Tech Tips
Use the same procedure for the RH side and LH side.
Disengage the 4 claws and remove the rear bumper assembly as shown in the illustration.
w/ LEXUS Parking Assist-Sensor System:
Disengage the clamp and remove the grommet.
REMOVE REAR BUMPER ENERGY ABSORBER
Remove the rear bumper energy absorber.
REMOVE ELECTRICAL KEY OSCILLATOR (ELECTRICAL KEY ANTENNA)
Disconnect the connector.
Remove the 2 nuts and the electrical key oscillator (electrical key antenna).