ENTRY AND START SYSTEM (for Start Function), Diagnostic DTC:B2283

DTC Code DTC Name
B2283 Vehicle Speed Sensor Malfunction

DESCRIPTION

The skid control ECU converts these signals into 4-pulse signals and sends them to the combination meter. After this signal is converted into a more precise rectangular waveform by the waveform shaping circuit inside the combination meter, it is then transmitted to the power source control ECU. The power source control ECU determines the vehicle speed based on the frequency of these pulse signals.

Tech Tips

When the power source control ECU is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.

DTC No. DTC Detection Condition Trouble Area
B2283

When both conditions below are met:


  • Over-deceleration in vehicle speed


  • Vehicle speed and engine speed do not match

  • DTC B2282 detection area

  • Combination meter

  • Speed sensor

  • Skid control ECU

  • Wire harness or connector
A01607QE05

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK FOR DTC


    1. Clear the DTC Click here.

    2. Check for DTC B2282 and DTC B2283.

      OK
      Display (DTC output) Proceed to
      "DTC B2283" only A
      "DTC B2283" and "DTC B2282" are output B
      DTC is not output C

      Tech Tips

      If DTC B2282 and DTC B2283 are output, perform troubleshooting for DTC B2282 first.


    B

    GO TO OTHER FLOW CHART (DTC B2282) Click here

    C

    USE SIMULATION METHOD TO CHECK Click here

    A

  2. CHECK FOR DTC


    1. Check for DTC.

      Tech Tips

      If vehicle stability control system DTCs are output, perform troubleshooting for vehicle stability control system DTCs.


    NG

    GO TO DIAGNOSTIC TROUBLE CODE CHART (VEHICLE STABILITY CONTROL SYSTEM) Click here

    OK

  3. READ VALUE USING INTELLIGENT TESTER (VEHICLE SPEED SIGNAL)


    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG).

    3. Check the Data List for proper functioning of the vehicle speed signal.

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Vehicle Speed Signal Vehicle speed signal / STOP or RUN

      STOP: Vehicle is stopped

      RUN: Vehicle is running

      		 -
      OK
      STOP (vehicle is stopped) and RUN (vehicle is running) appear on the screen.

    NG

    GO TO METER / GAUGE SYSTEM (SPEEDOMETER MALFUNCTION) Click here

    OK

    REPLACE POWER SOURCE CONTROL ECU