ENTRY AND START SYSTEM (for Entry Function) CUSTOMIZE PARAMETERS


  1. CUSTOMIZING FUNCTION WITH INTELLIGENT TESTER

    Tech Tips

    The items in the table below can be customized.

    Note


    • When the customer requests a change in a function, first make sure that the function can be customized.

    • Be sure to make a note of the current setting before customizing.

    • When troubleshooting a function, first make sure that the function is set to the default setting.

    Tech Tips

    The following functions default settings are ON. Parts of these functions can be customized.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus: Body / Entry & Start / Utility / Customize Setting.

    5. Select the setting by referring to the table below.

      Entry & Start
      Tester Display Default Content Setting
      Ignition Available Area ALL Function that switches the entry ignition detection area FRONT / ALL
      Park Wait Time 2.5s Function that sets waiting time to permit opening door after door is locked with entry lock function 0.5 s / 1.5 s / 2.5 s / 5 s
      Trunk Open Mode ON Function to permit opening luggage compartment door ON / OFF
      Key Low Battery Warning ON Function that warns driver that key's battery is low ON / OFF

  2. Entry Unlock Mode Switching Function


    1. To change the vehicle to entry unlock mode switching function, make sure that the vehicle power is off and simultaneously press and hold the electrical key's LOCK switch and another electrical key switch for 5 seconds.


      • All door unlock default setting:

        When the switches are pressed and held for 5 seconds, the entry door unlock mode changes in the following order: driver door mode, all door mode.

      Note

      After pressing and holding the switches for 5 seconds, wait 5 seconds before performing the same procedure again.


      • Driver door unlock mode:

        When the driver door's touch sensor is touched, only the driver door unlocks. When another touch sensor is touched, all doors unlock.

      • All door unlock mode:

        When the touch sensor is touched, all doors unlock.

    2. The certification ECU (smart key ECU assembly) receives this signal from the entry door control receiver and changes the entry and start system to the entry unlock mode.

    3. The certification ECU (smart key ECU assembly) sounds the buzzers of the wireless door lock buzzer and combination meter to inform the user that the mode has been switched.

      A015YYHE04

      Tech Tips


      • The function only changes the entry unlock mode of the entry and start system. It does not switch the unlocking of the wireless door lock control.

      • The above illustration is for LHD vehicles. For RHD vehicles, the left side and right side are reversed.

  3. Electrical Key Cancel

    The electrical key cancel operation disables the following functions:


    • Entry Unlock/Lock

    • Entry Luggage Compartment Open

    • Electrical Key Lock-in Prevention

    • Warning

    • Memory Call


    1. The operation procedures are as follows:

      Precondition:

      Engine switch off, driver side door closed and unlocked.


      1. Unlock the driver side door once with the UNLOCK switch of the electrical key.

      2. Open the driver door within 5 seconds.

      3. Unlock the driver side door twice with the UNLOCK switch of the electrical key within 5 seconds.

      4. Repeat open → close twice for the driver door within 30 seconds, and open again.

        (Driver door: Open → Close → Open → Close → Open)

      5. Unlock the driver side door twice with the UNLOCK switch of the electrical key within 5 seconds.

      6. Repeat open → close once for the driver door within 30 seconds, and open again.

        (Driver door: Open → Close → Open)

      7. Close the driver door within 5 seconds.

        When electrical key cancel is activated, the wireless door lock buzzer sounds twice.

        To return to the original condition, perform the procedures again. When the original condition is returned, the wireless door lock buzzer sounds once.