DOOR CONTROL RECEIVER (for Rear Side) REMOVAL


  1. REMOVE REAR SEAT HEADREST ASSEMBLY LH

  2. REMOVE REAR SEAT HEADREST ASSEMBLY RH

  3. REMOVE REAR SEAT CUSHION ASSEMBLY


    1. A0160U2E01

      Disengage the 2 front hooks of the rear seat cushion assembly from the vehicle body.

      Note

      Follow the instructions below carefully as the cushion frame deforms easily.


      1. Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.

      2. Repeat for the other hook.

    2. Disengage the 2 rear hooks of the seat cushion from the child restraint seat anchor bracket.

    3. Remove the rear seat cushion assembly.

  4. REMOVE REAR SEATBACK ASSEMBLY


    1. A016232E01

      Using a screwdriver with the tip tapes, disengage the 2 claws to open the 2 cap of the rear seat shoulder belt guide LH.

    2. A01622LE01

      Using a screwdriver with the tip tapes, disengage the 2 claws to open the 2 caps of the rear seat shoulder belt guide RH.

    3. A0163EJ

      Remove the 4 bolts.

    4. Disengage the 3 hooks and remove the rear seatback assembly

  5. REMOVE REAR DOOR SCUFF PLATE LH


    1. A0161QSE01

      Put protective tape around the rear door scuff plate.

    2. Using a moulding remover, disengage the 2 clips.

    3. A015YIJ

      Disengage the 5 claws and remove the the rear door scuff plate LH.

  6. REMOVE REAR DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure for the RH side and LH side.

  7. REMOVE REAR SEAT SIDE GARNISH LH


    1. A0163A2

      Disengage the 5 claws and remove the rear seat side garnish LH.

  8. REMOVE REAR SEAT SIDE GARNISH RH

    Tech Tips

    Use the same procedure for the RH side and LH side.

  9. REMOVE ROOF SIDE INNER GARNISH LH


    1. A01626A

      Disengage the 4 clips and claw, and remove the roof side inner garnish LH.

  10. REMOVE ROOF SIDE INNER GARNISH RH

    Tech Tips

    Use the same procedure for the RH side and LH side.

  11. REMOVE CENTER STOP LIGHT SET


    1. A0163GQ

      Disengage the 2 claws.

    2. Disengage the 2 guides and disconnect the center stop light set.

    3. Disconnect the connector and remove the center stop light set.

  12. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY


    1. A0160YN

      Remove the bolt and disconnect the floor end of the rear seat 3 point type belt assembly LH.

      Tech Tips

      Use the same procedures for the RH side and the LH side.

    2. A0162QH

      Using a moulding remover, disengage the 4 claws and remove the rear seat shoulder belt cover LH.

      Tech Tips

      Use the same procedures for the RH side and LH side.

    3. A015YRT

      Disengage the 3 clips.

    4. Pass the 2 rear seat belt floor anchors through the package tray trim panel assembly.

    5. Disengage the 5 claws and remove the package tray trim panel assembly.

  13. REMOVE DOOR CONTROL RECEIVER


    1. A016327

      Disconnect the connector.

    2. Remove the bolt and door control receiver.