DESCRIPTION
This DTC is detected if communication between the double lock door control relay and gateway ECU stops for more than 10 seconds.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1249 | Double lock door control relay communication stops |
|
WIRING DIAGRAM
INSPECTION PROCEDURE
Tech Tips
If "+B of GND short malfunction of communication bus" DTCs (B1214 and B1215) are detected at the same time as "communication stop" DTC B1249, repair the "+B or GND short malfunction of communication bus" DTCs first Click here.
PROCEDURE
INSPECT FUSE (MPX-B, DOOR DL)
Remove the MPX-B fuse from the engine room relay block No. 1.
Remove the DOOR DL fuse from the main body ECU RH (cowl side junction block RH).
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | |||||||||
|---|---|---|---|---|---|---|---|---|---|
|
| NG |
|
REPLACE FUSE |
| OK |
|
CHECK HARNESS AND CONNECTOR (DOUBLE LOCK DOOR CONTROL RELAY - BATTERY AND BODY GROUND)
Disconnect the P34 ECU connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Standard Voltage | |||||||||
|---|---|---|---|---|---|---|---|---|---|
|
| Standard Resistance | ||||||
|---|---|---|---|---|---|---|
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR (DOUBLE LOCK DOOR CONTROL ECU - BATTERY AND BODY GROUND) |
| OK |
|
CHECK HARNESS AND CONNECTOR (COMMUNICATION LINE)
Disconnect the P34 and P33 ECU connectors.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | |||||||||
|---|---|---|---|---|---|---|---|---|---|
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR (COMMUNICATION LINE) |
| OK |
|
REPLACE DOUBLE LOCK DOOR CONTROL RELAY