DESCRIPTION
This DTC is detected if communication between the rain sensor and gateway ECU stops for more than 10 seconds.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1279 | Rain sensor communication stops |
|
WIRING DIAGRAM
INSPECTION PROCEDURE
Tech Tips
If "+B of GND short malfunction of communication bus" DTCs (B1214 and B1215) are detected at the same time as "communication stop" DTC B1279, repair the "+B or GND short malfunction of communication bus" DTCs first Click here.
PROCEDURE
INSPECT FUSE (SECURITY)
Remove the SECURITY fuse from the main body ECU LH (cowl side junction block LH).
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | ||||||
|---|---|---|---|---|---|---|
|
| NG |
|
REPLACE FUSE (SECURITY) |
| OK |
|
CHECK HARNESS AND CONNECTOR (RAIN SENSOR - BATTERY AND BODY GROUND)
Disconnect the R7 connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Standard Voltage | ||||||
|---|---|---|---|---|---|---|
|
| Standard Resistance | ||||||
|---|---|---|---|---|---|---|
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR (RAIN SENSOR - BATTERY AND BODY GROUND) |
| OK |
|
CHECK HARNESS AND CONNECTOR (COMMUNICATION LINE)
Disconnect the R7 and R5 ECU connectors.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | |||||||||
|---|---|---|---|---|---|---|---|---|---|
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR (COMMUNICATION LINE) |
| OK |
|
REPLACE RAIN SENSOR Click here