PARKING ASSIST MONITOR SYSTEM Display Signal Circuit between Television Camera ECU and Multi-display

DESCRIPTION

This is the display signal circuit from the television camera ECU to the multi-display.

WIRING DIAGRAM

A0160ENE03

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY - TELEVISION CAMERA ECU)


    1. A0161R7E03

      Disconnect the J102 connector from the multi-display and the J103 connector from the television camera ECU.

    2. A0161R7E04

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      J102-1 (GVI+) - J103-1 (GVO+) Always Below 1 Ω
      J102-2 (GVI-) - J103-2 (GVO-) Always Below 1 Ω
      J102-3 (GVG1) - J103-3 (GVG1) Always Below 1 Ω
      J102-2 (GVI-) - Body ground Always 10 kΩ or higher
      J102-1 (GVI+) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE Click here