ULTRASONIC SENSOR (for Front Side) REMOVAL


  1. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01638L

      Using a clip remover, remove the 9 clips and cool air intake duct seal.

  2. REMOVE RADIATOR GRILLE PROTECTOR


    1. A01623G

      Remove the 2 radiator grille protectors.

  3. REMOVE FRONT BUMPER ASSEMBLY


    1. A0162OR

      Using a screwdriver, turn the pins 90 degrees and remove the 2 pin hold clips.

      Tech Tips


      • Tape the screwdriver tip before use.

      • Use the same procedure for the RH side and LH side.

    2. A0162S2

      remove the screw.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    3. A0163H6E01

      Put protective tape around the front bumper assembly.

    4. Remove the 8 screws.

    5. A0161S5

      Using a clip remover, remove the 2 clips and screw.

    6. A01617S

      Disengage the 10 claws and disconnect the front bumper assembly as shown in the illustration.

    7. w/ LEXUS Parking Assist-Sensor system:


      1. Disconnect the ultrasonic sensor connector.

    8. Disconnect the headlight cleaner hose.

      Note

      Prepare a drain pan or a piece of cloth in case washer fluid leaks.

    9. Disconnect the 2 fog light connectors and remove the front bumper assembly.

  4. REMOVE NO. 1 ULTRASONIC SENSOR


    1. Disconnect the sensor connector.

    2. A01606O

      Remove the sensor retainer as shown in the illustration.

    3. Remove the No. 1 ultrasonic sensor from the front bumper.