PARKING ASSIST MONITOR SYSTEM DTC CHECK / CLEAR

Tech Tips


  • Illustrations may differ from the actual vehicle depending on the device settings and options. Therefore, some detailed areas may not be shown exactly the same as on the actual vehicle.

  • If the system cannot enter the diagnostic mode, inspect all AVC-LAN communication components and repair or replace problem parts Click here.

  • After turning the engine switch on (IG), check that the map is displayed before starting the diagnostic mode. Otherwise, some items cannot be checked.


  1. START DIAGNOSTIC MODE


    1. There are 2 methods to start diagnostic mode. Use one of them.

    2. A015ZRME01

      Method 1


      1. Start the engine.

      2. While pressing and holding the "INFO" switch, operate the light control switch: OFF → Turn ON → Turn OFF → Turn ON → Turn OFF → Turn ON → Turn OFF.

      3. The diagnostic mode starts and the "System Check Mode" screen will be displayed. Service inspection starts automatically and the result will be displayed.

    3. A0161IM

      Method 2


      1. Start the engine.

      2. Switch to the "Display Check" screen.

      3. From the display quality adjustment screen, touch the corners of the screen in the following order: upper left → lower left → upper left → lower left → upper left → lower left.

      4. The diagnostic mode starts and the "System Check Mode" screen will be displayed. Service inspection starts automatically and the result will be displayed.

  2. FINISH DIAGNOSTIC MODE


    1. There are 2 methods to end diagnostic mode. Use one of them.


      1. Turn the engine switch off.

      2. Press and hold the "DISP" switch for 3 seconds.

  3. DIAGNOSIS MENU


    1. A0160ABE10

      The "Diagnosis MENU" screen will be displayed by pressing the menu switch on the "System Check Mode" screen.

  4. CHECK DTC


    1. A0161DIE12

      Read the system check result.


      1. If the check result is "EXCH", "CHEK" or "Old", touch the displayed check result to view the results on the "Unit Check Mode" screen and record them.

        Tech Tips


        • If all check results are "OK", go to communication DTC check.

        • If a device name is not known, its physical address is displayed.

        Tech Tips

        When proceeding to view the results of another device, press the service switch to return to the "System Check Mode" screen. Repeat this step.

    2. A0160NLE05

      Read the communication diagnostic check result.


      1. Return to the "System Check Mode" screen, and press the "LAN Mon" switch to enter the "LAN Monitor" screen.

      2. A0160JCE01

        If the check result is "CHEK" or "Old", touch the displayed check result to view the results on the individual communication diagnostic screen and record them.

        Tech Tips


        • If all check results are "No Err", the system judges that no DTC exists.

        • The sub-code (relevant device) will be indicated by its physical address.

        • When proceeding to view the results of another device, press the "Service" switch to return to the original "LAN Monitor" screen. Repeat this step.

  5. DTC CLEAR/RECHECK


    1. A01605VE02

      Clear the DTC


      1. Press the "Code CLR" switch for 3 seconds.

      2. The check results are cleared.

    2. A0160HDE01

      Recheck


      1. Press the "Recheck" switch.

      2. A015ZZ9E01

        Confirm that all diagnostic codes are "OK" when the check results are displayed. If a code other than "OK" is displayed, troubleshoot again.

      3. A015ZZ9E02

        Press the "LAN Mon" switch to change to the "LAN Monitor" screen.

      4. A0160NPE01

        Confirm that all diagnostic codes are "No Err". If a code other than "No Err" is displayed, troubleshoot again.