PARKING ASSIST MONITOR SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

Tech Tips


  • Use the following procedure to troubleshoot the parking assist monitor system.

  • *: Use the intelligent tester.


  1. VEHICLE BROUGHT TO WORKSHOP


    NEXT

  2. INSPECT BATTERY VOLTAGE


    1. Measure the battery voltage.

      Standard Voltage
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.


      NEXT

  3. CHECK IF SAME SYMPTOM APPEARS IN OTHER SYSTEM


    1. Refer to the navigation system Click here.

      Result
      Result Proceed to
      Navigation system is normal A
      Navigation system is abnormal B

      B

      GO TO NAVIGATION SYSTEM Click here

      A

  4. CHECK COMMUNICATION FUNCTION OF MULTIPLEX COMMUNICATION SYSTEM (BEAN COMMUNICATION)*


    1. Use the intelligent tester to check if the multiplex communication system is functioning normally Click here.

      Result
      Result Proceed to
      DTCs for multiplex communication system are not output A
      DTCs for multiplex communication system are output B

      B

      GO TO MULTIPLEX COMMUNICATION SYSTEM Click here

      A

  5. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*


    1. Use the intelligent tester to check if the CAN communication system is functioning normally Click here.

      Result
      Result Proceed to
      DTCs for CAN communication system are not output A
      DTCs for CAN communication system are output B

      B

      GO TO CAN COMMUNICATION SYSTEM Click here

      A

  6. CHECK FOR DTC*


    1. Check for DTCs and note any codes that are output Click here.

    2. Clear the DTCs Click here.

    3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

      Note

      The multi-media module receiver assembly outputs DTCs for the following systems. When DTCs other than those in Diagnostic Trouble Code Chart for the parking assist monitor system are output, refer to Diagnostic Trouble Code Chart for the relevant systems.

      System Proceed to
      Navigation System

      Click here

      Result
      Result Proceed to
      No DTCs are output A
      DTCs for parking assist monitor system are output B
      DTCs for navigation system are output C

      B

      Go to step 9
      C

      GO TO NAVIGATION SYSTEM Click here

      A

  7. PROBLEM SYMPTOMS TABLE


    1. Refer to the Problem Symptoms Table Click here.

      Result
      Result Proceed to
      Fault is not listed in Problem Symptoms Table A
      Fault is listed in Problem Symptoms Table B

      B

      Go to step 9
      A

  8. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Diagnosis System Click here

    2. Terminals of ECU Click here

    3. Data List / Active Test Click here


      NEXT

  9. ADJUST, REPAIR OR REPLACE


    NEXT

  10. CONFIRMATION TEST


    NEXT
    END