AUDIO AND VISUAL SYSTEM (w/o Navigation System) Mute Signal Circuit between Radio Receiver and Stereo Component Amplifier

DESCRIPTION

This circuit sends a signal to the stereo component amplifier assembly to mute noise. Because of that, the noise produced by changing the sound source ceases.

If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.

If there is a short in the circuit, even though the stereo component amplifier assembly is functioning, no sound, or only an extremely faint sound, can be heard.

WIRING DIAGRAM

A0160ARE22

INSPECTION PROCEDURE

PROCEDURE


  1. INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY


    1. A015YZKE10
      Text in Illustration
      *1

      Component with harness connected

      (Stereo Component Amplifier Assembly)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      P30-1 (MUTE) - Body ground Engine switch on (ACC), audio system is playing → Changing sources Above 2.5 V → Below 0.5 V

    NG

    CHECK HARNESS AND CONNECTOR Click here

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

  2. CHECK HARNESS AND CONNECTOR


    1. Disconnect the radio receiver assembly and stereo component amplifier assembly connectors.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      J107-7 (MUTE) - P30-1 (MUTE) Always Below 1 Ω
      J107-7 (MUTE) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY (OUTPUT SIGNAL)


    1. A015ZK7E50
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Radio Receiver Assembly)

      Reconnect the stereo component amplifier assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      J107-7 (MUTE) - Body ground Engine switch on (ACC), audio system is playing Above 2.5 V

    NG

    REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY Click here

    OK

    REPLACE RADIO RECEIVER ASSEMBLY Click here