AUDIO AND VISUAL SYSTEM Integration Control and Panel Assembly Power Source Circuit

DESCRIPTION

This is the power source circuit to operate the integration control & panel assembly.

WIRING DIAGRAM

A0160EEE27

INSPECTION PROCEDURE

PROCEDURE


  1. INSPECT INTEGRATION CONTROL & PANEL ASSEMBLY


    1. A0160Z6E04

      Disconnect the integration control & panel assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      J54-8 (E) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      J54-14 (B) - J54-8 (E) Always 11 to 14 V
      J54-5 (ACC) - J54-8 (E) Engine switch on (ACC) 11 to 14 V
      J54-4 (IG+) - J54-8 (E) Engine switch on (IG) 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE Click here