AUDIO AND VISUAL SYSTEM Radio Receiver Communication Error

INSPECTION PROCEDURE

PROCEDURE


  1. IDENTIFY THE COMPONENT SHOWN BY SUB-CODE


    1. Enter the diagnostic mode.

      A015YUYE18

    2. Press the preset switch "3" to change to "Detailed Information Mode".

    3. Identify the component shown by the sub-code.

      Tech Tips


      • "190 (radio receiver)" is the component shown by the sub-code in the example shown in the illustration.


      • For details of the DTC display, refer to DTC Check / Clear Click here.


    NEXT

  2. CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE


    1. Inspect the power source circuit of the component shown by the sub-code.

      If the power source circuit is operating normally, proceed to the next step.

      Component Table
      Component Proceed to
      Gateway ECU (1C6)

      Gateway ECU Power Source Circuit Click here

      Stereo component amplifier (440)

      Stereo Component Amplifier Power Source Circuit Click here

      Integration control & panel assembly (1D8)

      Integration Control & Panel Assembly Power Source Circuit Click here


    NEXT

  3. INSPECT RADIO RECEIVER


    1. Disconnect the radio receiver connectors.

      A015YOTE01

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      J66-5 (ATX+) - J66-15 (ATX-) Always 60 to 80 Ω
      J65-9 (TXM+) - J65-10 (TXM-) Always 60 to 80 Ω
      J63-9 (TX+) - J63-10 (TX-) Always 60 to 80 Ω

    NG

    REPLACE RADIO RECEIVER Click here

    OK

  4. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - COMPONENT SHOWN BY SUB-CODE)

    Tech Tips


    • Start the check from the circuit that is near the component shown by the sub-code first.


    • For details of the connectors, refer to Terminals of ECU Click here.


    1. Referring to AVC-LAN Wiring Diagram below, check the AVC-LAN circuit between the radio receiver and the component shown by the sub-code.


      1. Disconnect all connectors between the radio receiver and the component shown by sub-code.

      2. Check for an open or short in the AVC-LAN circuit between the radio receiver and the component shown by the sub-code.

        OK
        There are no open or short circuits.
        A015YWSE01

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  5. REPLACE COMPONENT SHOWN BY SUB-CODE


    1. Replace the component shown by the sub-code with a known good one and check if the same problem occurs again.

      OK
      Same problem does not occur.

    NG

    REPLACE RADIO RECEIVER Click here

    OK

    END