STEERING LOCK SYSTEM PRECAUTION


  1. NOTICE FOR INITIALIZATION

    Note

    When disconnecting the cable from the negative battery terminal, the following system needs to be initialized after the cable is reconnected.

    System Name See Procedure
    Power Window Control System

    Click here

    Parking Assist Monitor System

  2. PRECAUTIONS WHEN WORKING ON ELECTRIC STEERING LOCK


    1. After replacing the steering lock actuator assembly (steering lock ECU), perform the key code registration.

    2. If the steering lock actuator assembly is replaced, open and close the driver's door. The engine may not start until either operation is performed.

      Tech Tips

      Opening and closing the driver's door causes the steering lock actuator assembly (steering lock ECU) to memorize the correct steering lock bar position.

    3. If checking for DTCs of the push-button start function or checking the Data List with the engine switch off, make sure that the driver's door is open.

      Tech Tips

      When the engine switch is off, the main body ECU RH (cowl side junction block RH) may be in a sleep mode. If the main body ECU RH (cowl side junction block RH) is in this sleep mode, it will not be possible to communicate with the Intelligent Tester.