PARKING BRAKE SWITCH INSTALLATION


  1. INSTALL PARKING BRAKE SWITCH ASSEMBLY (for LHD)


    1. A015ZUW

      Install the parking brake switch assembly to the parking brake control pedal assembly with the screw.

      Torque:
      0.9 N*m  { 9 kgf*cm, 8 in.*lbf }

    2. Install the tension spring to the parking brake control pedal assembly.

  2. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY (for LHD)


    1. A0161CJE01

      Install the parking brake control pedal assembly and temporarily tighten the 3 nuts.

    2. Fully tighten the 3 nuts in the order shown in the illustration.

      Torque:
      13 N*m  { 133 kgf*cm, 10 ft.*lbf }

    3. Connect the parking brake switch connector.

    4. A0162J9

      Install the instrument panel junction block assembly with the 2 nuts.

    5. Install the parking brake control pedal assembly to the body with the 3 nuts.

      A015Z6V
      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

  3. INSTALL PARKING BRAKE SWITCH ASSEMBLY (for RHD)


    1. A016300

      Install the parking brake switch assembly to the parking brake control pedal assembly with the screw.

      Torque:
      0.9 N*m  { 9 kgf*cm, 8 in.*lbf }

    2. Install the tension spring to the parking brake control pedal assembly.

  4. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY (for RHD)


    1. A0161T9E01

      Install the parking brake control pedal assembly to the body and temporarily tighten the bolt and 2 nuts.

    2. Fully tighten the bolt and 2 nuts in the order shown in the illustration.

      Torque:
      13 N*m  { 133 kgf*cm, 10 ft.*lbf }

    3. Connect the parking brake switch connector.

    4. A0162DZ

      Install the parking brake control pedal assembly with the 2 nuts.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

  5. INSTALL NO. 1 AIR DUCT (for RHD)


    1. A015ZGF

      Engage the claw and guide, and install the No. 1 air duct.

  6. INSTALL NO. 2 REAR AIR DUCT (for LHD)

  7. INSTALL NO. 1 REAR AIR DUCT (for RHD)

  8. INSTALL REAR AIR DUCT GUIDE LH (for LHD)

  9. INSTALL REAR AIR DUCT GUIDE RH (for RHD)

  10. INSTALL FRONT FLOOR SILENCER PAD LH (for LHD)

  11. INSTALL FRONT FLOOR SILENCER PAD RH (for RHD)

  12. INSTALL NO. 3 DASH PANEL INSULATOR PAD

  13. INSTALL FRONT FLOOR FOOTREST LH (for LHD)

  14. INSTALL FRONT FLOOR FOOTREST RH (for RHD)

  15. INSTALL LOWER CENTER PILLAR GARNISH LH (for LHD)


    1. A01604OE01

      Engage the 5 clips and 3 claws, and install the lower center pillar garnish LH.

  16. INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH (for LHD)


    1. A015Z32

      Install the front seat outer belt assembly LH with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  17. INSTALL REAR DOOR SCUFF PLATE LH (for LHD)


    1. A016266

      Engage the 2 clips.

    2. A015YIJ

      Engage the 5 claws and install the rear door scuff plate LH.

  18. INSTALL LOWER CENTER PILLAR GARNISH RH (for RHD)

    Tech Tips

    Use the same procedure for the RH side and the LH side.

  19. INSTALL FRONT SEAT OUTER BELT ASSEMBLY RH (for RHD)

    Tech Tips

    Use the same procedure for the RH side and the LH side.

  20. INSTALL REAR DOOR SCUFF PLATE RH (for RHD)

    Tech Tips

    Use the same procedure for the RH side and the LH side.

  21. INSTALL LAP BELT OUTER ANCHOR COVER


    1. A0162EC

      Engage the 2 claws and install the lap belt outer anchor cover as shown in the illustration.

      Tech Tips

      Use the same procedure to install the cover on the other side.

  22. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY

    Click here

  23. INSTALL NO. 2 CONSOLE BOX DUCT


    1. A0162NO

      Install the No. 2 console box duct with the 2 clips.

  24. INSTALL CONSOLE BOX

    Click here

  25. INSTALL FRONT SEAT ASSEMBLY LH (for LHD)

    Click here

  26. INSTALL FRONT SEAT ASSEMBLY RH (for RHD)

    Tech Tips

    Use the same procedure for the LH side and RH side Click here.

  27. INSPECT BRAKE WARNING LIGHT


    1. When operating the parking brake pedal, check that the brake warning light illuminates.

      Standard
      The brake warning light always illuminates at the first click.