VEHICLE STABILITY CONTROL SYSTEM TS and CG Terminal Circuit

DESCRIPTION

In Test Mode (signal check), a malfunction in a speed sensor that cannot be detected when the vehicle is stopped can be detected while driving.

Sensor check mode can be entered by connecting terminals TS and CG of the DLC3 and turning the engine switch from off to on (IG).

WIRING DIAGRAM

A015ZS4E14

INSPECTION PROCEDURE

Note

When replacing the skid control ECU, perform zero point calibration and store system information Click here.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - TS of DLC3)


    1. A015YOOE03

      Disconnect the skid control ECU connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      J77-13 (TS) - J21-12 (TS) Always Below 1 Ω
      J77-13 (TS) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)


    1. A01605PE33

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      J21-4 (CG) - Body ground Always Below 1 Ω

      Tech Tips

      If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part Click here.


    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE SKID CONTROL ECU Click here