YAW RATE AND ACCELERATION SENSOR INSTALLATION


  1. INSTALL YAW RATE AND ACCELERATION SENSOR


    1. A015ZGD

      Connect the yaw rate and acceleration sensor connector.

    2. A015ZAEE04

      Install the yaw rate and acceleration sensor with the 2 bolts.

      Torque:
      15 N*m  { 148 kgf*cm, 11 ft.*lbf }

      Note


      • Do not damage the yaw rate and acceleration sensor.

      • Make sure that the yaw rate and acceleration sensor is installed securely.

    3. Install the 2 wire harness clamps.

  2. INSTALL NO. 2 CONSOLE BOX DUCT


    1. A0162NO

      Install the No. 2 console box duct with the 2 clips.

  3. INSTALL CONSOLE BOX

    Tech Tips

    Refer to the instructions for installation of the console box Click here.

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. OBTAIN ZERO POINT OF YAW RATE AND ACCELERATION SENSOR

    Tech Tips

    Obtain zero point of the yaw rate and acceleration sensor Click here.

  6. CHECK FOR SENSOR SIGNAL

    Tech Tips

    Check for sensor signal Click here.