VEHICLE STABILITY CONTROL SYSTEM ABS Warning Light Remains ON

DESCRIPTION

The skid control ECU is connected to the combination meter via the CAN and multiplex communication systems.

If any of the following is detected, the ABS warning light remains on:


WIRING DIAGRAM

A015Z31E01

INSPECTION PROCEDURE

Note

When replacing the skid control ECU, perform zero point calibration and store system information Click here.

PROCEDURE


  1. CHECK CAN COMMUNICATION SYSTEM


    1. Check if a CAN communication system DTC is output Click here.

      Result
      Result Proceed to
      DTC is not output A
      DTC is output B

    B

    INSPECT CAN COMMUNICATION SYSTEM Click here

    A

  2. CHECK MULTIPLEX COMMUNICATION SYSTEM


    1. Check if a multiplex communication system DTC is output Click here.

      Result
      Result Proceed to
      DTC is not output A
      DTC is output B

    B

    INSPECT MULTIPLEX COMMUNICATION SYSTEM Click here

    A

  3. CHECK IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED


    1. Check if the skid control ECU connector is securely connected.

      OK
      The connector is securely connected.

    NG

    CONNECT CONNECTOR TO ECU CORRECTLY Click here

    OK

  4. CHECK BATTERY


    1. Check the battery voltage.

      Standard Voltage
      11 to 14 V

    NG

    CHECK OR REPLACE CHARGING SYSTEM OR BATTERY (for 2UR-GSE) Click here

    OK

  5. INSPECT SKID CONTROL ECU (IG1 TERMINAL)


    1. A0163E5E06

      Disconnect the skid control ECU connector.

    2. Turn the engine switch on (IG).

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      J77-1 (IG1) - Body ground Engine switch on (IG) 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (IG1 CIRCUIT)

    OK

  6. INSPECT SKID CONTROL ECU (GND TERMINAL)


    1. A015ZCGE04

      Turn the engine switch off.

    2. Disconnect the skid control ECU connectors.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      J78-26 (GND1) - Body ground Always Below 1 Ω
      J78-14 (GND2) - Body ground Always Below 1 Ω
      A35*1, J98*2-22 (GND3) - Body ground Always Below 1 Ω

      *1: for LHD

      *2: for RHD


    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (GND CIRCUIT)

    OK

  7. INSPECT COMBINATION METER ASSEMBLY


    1. Reconnect the skid control ECU connectors.

    2. Perform the Active Test of the combination meter (meter CPU) using the intelligent tester Click here.

    3. Check the combination meter.

      OK
      The ABS warning light turns on or off in accordance with the intelligent tester operation.

      Tech Tips

      If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part Click here.


    NG

    REPLACE COMBINATION METER ASSEMBLY Click here

    OK

    REPLACE SKID CONTROL ECU Click here