VEHICLE STABILITY CONTROL SYSTEM, Diagnostic DTC:C1432

DTC Code DTC Name
C1432 Steering Angle Sensor Power Source Voltage Malfunction

DESCRIPTION

Steering angle sensor signals are sent to the skid control ECU via the CAN communication system. When there is a malfunction in the CAN communication system, it will be detected by the steering angle sensor zero point malfunction diagnostic function.

DTC Code DTC Detection Condition Trouble Area
C1432 Steering angle sensor power supply malfunction signal is received from steering angle sensor.

  • Steering angle sensor power supply

  • Steering angle sensor

WIRING DIAGRAM

A015ZW3E26

INSPECTION PROCEDURE

Tech Tips


  • When DTC U0073, U0123, U0124 and/or U0126 is output together with DTC C1432, inspect and repair the trouble areas indicated by DTC U0073, U0123, U0124 and/or U0126 first Click here.

  • When the speed sensor or the yaw rate and acceleration sensor has trouble, DTCs for the steering angle sensor may be output even when the steering angle sensor is normal. When DTCs for the speed sensor or yaw rate and acceleration sensor are output together with DTCs for the steering angle sensor, inspect and repair the speed sensor and yaw rate and acceleration sensor first, and then inspect and repair the steering angle sensor.

PROCEDURE


  1. INSPECT STEERING ANGLE SENSOR (POWER SOURCE TERMINAL)


    1. A0160GCE29
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Steering Angle Sensor)

      Remove the steering wheel and the column cover lower.

    2. Make sure that there is no looseness at the locking part and the connecting part of the connectors.

    3. Disconnect the steering angle sensor connector.

    4. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      J23-1 (IG) - Body ground Engine switch on (IG) 11 to 14 V
      J23-3 (BAT) - Body ground Always 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)

    OK

  2. INSPECT STEERING ANGLE SENSOR (GROUND TERMINAL)


    1. A0160GCE30
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Steering Angle Sensor)

      Turn the engine switch off.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      J23-2 (ESS) - Body ground Always Below 1 Ω

      Tech Tips

      If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step Click here.


    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (GROUND CIRCUIT)

    OK

    REPLACE STEERING ANGLE SENSOR Click here