VEHICLE STABILITY CONTROL SYSTEM, Diagnostic DTC:C1427

DTC Code DTC Name
C1427 Motor Malfunction

DESCRIPTION

DTC Code DTC Detection Condition Trouble Area
C1427 Actuator pump motor does not operate properly.

  • Brake actuator assembly (Ground circuit)

  • Brake actuator assembly (Motor circuit)

WIRING DIAGRAM

Refer to DTCs C0273, C0274 and C1361 Click here.

INSPECTION PROCEDURE

Note

When replacing the brake actuator assembly, perform zero point calibration and store system information Click here.

PROCEDURE


  1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (ABS MOTOR RELAY)


    1. Connect the intelligent tester to the DLC3.

    2. Start the engine.

    3. Select the Active Test on the intelligent tester Click here.

      ABS/VSC/TRC
      Tester Display Test Part Control Range Diagnostic Note
      Motor Relay ABS motor relay Relay ON/OFF Operating sound of motor can be heard

    4. Check for operating sound of the ABS motor relay when operating it using the intelligent tester.

      Result
      Result Proceed to
      Operating sound is not heard A
      Operating sound is heard B

    B

    RECONFIRM DTC Click here

    A

  2. INSPECT SKID CONTROL ECU (GND2 TERMINAL)


    1. A0160DRE04
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Skid Control ECU)

      Turn the engine switch off.

    2. Make sure that there is no looseness at the locking part and the connecting part of the connectors.

    3. Disconnect the skid control ECU connector.

    4. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A62-13 (GND2) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (GND2 CIRCUIT)

    OK

  3. RECONFIRM DTC

    Tech Tips

    This code is detected when a problem is identified in the brake actuator assembly.

    The ABS motor relay is in the brake actuator assembly.

    Therefore, ABS motor relay unit inspection cannot be performed. Be sure to check if the DTC is output before replacing the brake actuator assembly.


    1. Turn the engine switch off.

    2. Reconnect the skid control ECU connector.

    3. Clear the DTCs Click here.

    4. Start the engine.

    5. Drive the vehicle at a speed of 20 km/h (12 mph) or more for 30 seconds or more.

    6. Check if the same DTC is recorded Click here.

      Result
      Result Proceed to
      DTC (C1427) is not output A
      DTC (C1427) is output B

      Tech Tips


      • If a speed signal of 6 km/h (4 mph) or more is input to the skid control ECU with the engine switch on (IG) and the stop light switch off, the ECU performs self diagnosis of the motor and solenoid circuits.

      • If no trouble codes are output, slightly jiggle the connectors, wire harness, and fuses of the brake actuator assembly. Make sure that no DTCs are output.

      • If any DTCs are output while jiggling a connector or wire harness of the brake actuator assembly (skid control ECU), inspect and repair the connector or wire harness. It is suspected that the DTCs were output due to a bad connection of the connector terminal.


    B

    REPLACE BRAKE ACTUATOR ASSEMBLY Click here

    A

    CHECK FOR INTERMITTENT PROBLEMS Click here