VEHICLE STABILITY CONTROL SYSTEM DTC CHECK / CLEAR


  1. DTC CHECK / CLEAR (When Using the Intelligent Tester)


    1. Check for DTCs.


      1. Connect the intelligent tester to the DLC3.

      2. Turn the engine switch on (IG).

      3. Turn the intelligent tester on.

      4. Read the DTCs following the prompts on the intelligent tester screen. Enter the following menus: Chassis / ABS/VSC/TRC / DTC.

      5. Check the details of the DTCs Click here.

    2. Clear the DTCs.


      1. Connect the intelligent tester to the DLC3.

      2. Turn the engine switch on (IG).

      3. Turn the intelligent tester on.

      4. Operate the intelligent tester to clear the codes. Enter the following menus: Chassis / ABS/VSC/TRC / DTC / Clear.

  2. DTC CHECK / CLEAR (When not Using the Intelligent Tester)


    1. Check for DTCs.


      1. A015ZUNE58

        Using SST, connect terminals TC and CG of the DLC3.

        SST
        09843-18040

      2. Turn the engine switch on (IG).

      3. Observe the blinking pattern of the ABS warning light and read the multi-information display in order to identify the DTC.

        Tech Tips

        If no code appears, inspect the TC and CG terminal circuit, and ABS warning and VSC warning (master caution indicator light and multi-information display) light circuits.

        Trouble Area See Procedure
        TC and CG terminal circuit

        Click here

        ABS warning light circuit (Remains on)

        Click here

        ABS warning light circuit (Does not come on)

        Click here

        VSC warning light (Master caution indicator light and multi-information display) circuit (Remains on)

        Click here

        VSC warning light (Master caution indicator light and multi-information display) circuit (Does not come on)

        Click here

      4. As an example, the illustration below shows the blinking patterns of the normal system code and trouble codes 11 and 21 for the ABS warning light, and display of normal system code and trouble code 43 for the VSC on the multi-information display.

        A01626JE01

      5. Check the details of the DTCs Click here.

        Tech Tips

        Illustrations may differ from the actual screen displayed depending on the specifications of the vehicle and customized settings.

      6. After completing the check, disconnect terminals TC and CG of the DLC3 to turn off the display.

        If 2 or more DTCs are detected at the same time, the DTCs will be displayed in ascending order.

    2. Clear the DTCs.


      1. A015ZUNE58

        Using SST, connect terminals TC and CG of the DLC3.

        SST
        09843-18040

      2. Turn the engine switch on (IG).

      3. A0160XC

        Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.

      4. Check that the warning light indicates a normal system code.

      5. Remove SST from the terminals of the DLC3.

        Tech Tips

        The DTCs cannot be cleared by disconnecting the negative cable from the battery terminal or the ECU-IG RH fuse.

  3. END OF DTC CHECK/CLEAR


    1. Turn the engine switch on (IG).

    2. Check that the ABS warning and master caution indicator lights go off within approximately 3 seconds after turning the engine switch on (IG).