PROPELLER SHAFT ASSEMBLY DISASSEMBLY


  1. REMOVE PROPELLER INTERMEDIATE SHAFT


    1. A0162MEE03

      Put matchmarks on the intermediate shaft and propeller shaft.

    2. Separate the intermediate shaft and propeller shaft.

      Note

      Be careful not to damage the splines.

    3. Remove the adjusting nut from the intermediate shaft.

    4. A015ZJRE01

      Remove the dust boot from the propeller shaft.

      Tech Tips

      If the dust boot is to be reused, remove it after wrapping vinyl tape around the spline to prevent damage.

  2. REMOVE NO. 1 CENTER SUPPORT BEARING ASSEMBLY


    1. A0163DN

      Using a snap ring expander, remove the No. 2 propeller shaft dust deflector snap ring.

    2. A01624RE01

      Using SST and a press, remove the No. 1 center support bearing assembly and No. 2 propeller shaft dust deflector.

      SST
      09950-00020
    3. A015ZB1E02

      Using SST and a press, remove the No. 1 propeller shaft dust deflector.

      SST
      09950-00020