OIL PUMP REASSEMBLY


  1. INSTALL FRONT OIL PUMP OIL SEAL


    1. A0161BHE01

      Using SST and a hammer, tap in a new oil seal.

      SST
      09350-30020   ( 09351-32140 )
      Standard depth
      -0.2 to 0.2 mm (-0.00787 to 0.00787 in.)

      Tech Tips

      The oil seal end should be flush with the outer edge of the pump body.

    2. Coat the lip of the oil seal with MP grease.

  2. SECURE FRONT OIL PUMP BODY SUB-ASSEMBLY


    1. Place the oil pump body on the torque converter clutch.

  3. INSTALL FRONT OIL PUMP DRIVEN GEAR


    1. A0160PI

      Coat the driven gear with ATF.

    2. Install the driven gear to the oil pump body.

  4. INSTALL FRONT OIL PUMP DRIVE GEAR


    1. A015Z69

      Coat the drive gear with ATF.

    2. Install the drive gear to the oil pump body.

  5. INSTALL FRONT OIL PUMP BODY O-RING


    1. A0163JFE01

      Coat a new O-ring with ATF.

    2. Install the O-ring to the oil pump body.

  6. INSTALL STATOR SHAFT ASSEMBLY


    1. A015ZUY

      Align the 2 bolt holes on the stator shaft and install the shaft as shown in the illustration.

    2. Install the 2 bolts.

      Torque:
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

  7. INSTALL STATOR SHAFT CLUTCH DRUM THRUST WASHER


    1. A015ZJV

      Align the 2 claws and install the thrust washer.

  8. INSTALL STATOR SHAFT PISTON


    1. A0162E0E01

      Coat 2 new O-rings with ATF and install them to the stator shaft piston.

    2. A01638K

      Install the stator shaft piston and stator shaft spring sub-assembly.

    3. Using a T30 ''TORX'' wrench, install the 5 bolts.

      Torque:
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

  9. INSPECT OIL PUMP DRIVE GEAR ROTATION


    1. A015ZQM

      Place the oil pump assembly on the torque converter clutch.

    2. Make sure that the drive gear rotates smoothly.

  10. INSTALL CLUTCH DRUM OIL SEAL RING


    1. Coat 4 new oil seal rings with ATF.

    2. A015Z54E02

      Squeeze the ends of the 4 oil seal rings so that the gap becomes 8 mm (0.315 in.) or less, and then install them to the stator shaft groove.

      Note

      Do not expand the ring ends excessively.

      Tech Tips

      After installing the oil seal rings, check that they rotate smoothly.

  11. INSTALL OIL PUMP O-RING


    1. A01632VE01

      Install a new O-ring to the oil pump.